No part of this publication may be reproduced, stored on a retrieval system, or transmitted, in any form or by any means electronic,mechanical, photocopying, recording, or otherwise, without the prior written permission of Harris Corporation. The use oftrademarks or other designations is for reference purposes only.NOTICEHarris Corporation makes no warranties about this document. Harris Corporation reserves the right to make hardware and softwarechanges to the product described within this document without prior notice and without obligation to notify any person of suchrevision or change.TRADEMARKSTS is a registered trademark of Harris Corporation.REGULATORY INFORMATIONWARNING: This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordancewith the installation manual, may cause interference to radio communications. It has been <strong>test</strong>ed and found to comply with the limitsfor a Class A digital device pursuant to Part 15, Subpart J of the FCC rules, which are designed to provide reasonable protectionagainst such interference when operated in a commercial environment. Operation of the equipment in a residential area is likely tocause interference, in which case the user, at his own expense, will be required to take whatever measures may be required tocorrect the interference.Declaration of ConformityManufacturer:Importer:Signature:Print:Harris CorporationNetwork Support Division809 Calle PlanoCamarillo, CA 93012 U.S.A.Ed Zoiss, Director of Engineering_____________________________________________________________________________________________________________________________________________________________________Standards Used:FCC part 15CISPR 22EN300386-2:97 EMC, ESD DirectivesEN61010.1 (1993). <strong>Safe</strong>ty Requirementsfor Electrical Equipment for Measurement,Control,and Laboratory Use.CSA/CAN C22.2 No. 1010.1-92 <strong>Safe</strong>tyModel: <strong>TS45S</strong>Serial: ____________________Harris Corporation officially declares the <strong>test</strong> equipment listed above is in conformity with ElectromagenticCompatibility Directive 89/336/EEC and Low Voltage Directive 73/23/EEC based on <strong>test</strong> results performed in atypical configuration. This Conformity is indicated by the following symbols representing the European Communityand compliance organizations:C®USNetwork Support Division | 809 Calle Plano | Camarillo, CA 93012-8519 USAwww.<strong>test</strong><strong>set</strong>s.harris.com 1-800-437-2266next level solutionsii©2000 Harris CorporationWritten/Printed in USA. 0II-727880-002, Issue 3, July 2001
Contents■ <strong>Safe</strong>ty Information 1■ Introduction 2■ Design Features 2■ Physical Characteristics 3■ Controls and Indicators 4■ Audio Controls 4■ Keypad Controls and Indicators 5■ Power and Connections 7■ Battery 7■ Line Cords 7■ Operation 8■ Talk/Monitor Switch 8■ Operating the Test Set in Monitor Mode 9■ Operating the Test Set in Talk Mode 9■ Data Lockout Operation 10■ Data <strong>Safe</strong> Practices 11■ Lockout Override Operation 12■ Operating Your Test Set on <strong>ADSL</strong> 13■ Configuring Your Test Set 14■ Maintenance 16■ Replacing the Battery 17■ Replacing the Belt Clip 17■ Replacing the Line Cord 19■ Warranty 21■ Non-Warranty 21■ Return or Repair of Equipment 22■ Specifications 22iii