OWNERS MANUAL - BR250-DN250 Go Kart - Baja Motorsports

BATTERY INSTALLATIONNote: The following page is for vehicles with battery’s containing separateelectrolyte pack. Most battery’s will come with the electrolyte already sealedinto the battery.Preparing the battery:· Place battery on level surface. Remove sealing tapefrom top. (see figure A)· Take the electrolyte container out of the plastic bag.· Place electrolyte container upside down with thesealed silver mouths of the electrolyte bottles in linewith the six filler holes of the battery. (see figure B)· Push the container down strongly enough to breakthe silver seals. (see figure B)· As electrolyte starts flowing into battery, airbubbles will come up from the mouths of the plasticelectrolyte bottles.· Leave bottles upside down in battery holes untilelectrolyte is completely drained.· Never leave children unattended around battery.· If air bubbles cease to float to the top of theelectrolyte bottles, tap lightly on top.· DO NOT remove container from battery while it isdraining.· Never cut or pierce electrolyte container.· After all the electrolyte has drained from the bottlesinto the battery, pull plastic electrolyte bottles gentlyout of the battery.· Discard empty electrolyte bottles in a waste areathat is inaccessible to children and animals.· After filling let battery stand for at least 30 minutesbefore charging. This allows the electrolyte topenetrate plates for optimum performance andensures longer battery life.· After 30 minutes the battery is ready for its initialcharge. Place cap strip loosely over the filling holesas shown in the picture. (see figure C)Figure AFigure BFigure C28