elevator shaft mounting instructions - mod. âlaquilaâ - Donzelli Srl

More documents

Recommendations

Info

ELEVATOR SHAFT MOUNTING INSTRUCTIONS - MOD. “LAQUILA”Rel. 03 February 2011UPRIGHTS PIT FASTENING• NOTE: Materials required to perform this stepare supplied in blister pack code “DZ9F2201– M12 anchor bolts Kit”• After plumbing the structure, make a Ø12 holeat least 100 mm deep as shown on the figure.• Fasten the uprights to the pit slab using theanchor bolts supplied.1PART LIST1 M12 ANCHOR BOLT<strong>Donzelli</strong> S.r.l. Via Bizzozzero, 106 – 20032 Cormano (MI) Tel. +39 02 66301849 Fax +39 02 6152041 info@donzellisrl.com PAGE 12 / 29
ELEVATOR SHAFT MOUNTING INSTRUCTIONS - MOD. “LAQUILA”Rel. 03 February 2011GLASS HOLDING PROFILE• NOTE: Materials required for this step issupplied in box code “DZ9F217 - Crossbarand Glass Holder Hardware Kit”• The glass holding profiles are supplied indifferent lengths based on the size of thevarious mirrors. Please refer to the projectdrawing to identify which one is needed.1• Position the glass holding profile as shown onFigure “B”. Make sure to align the edgesindicated with the arrows.• Fasten the profile using the countersunk selfthreadingscrews.2• IMPORTANT: Use at least 2 screws to fasteneach profile. Use only the countersunk holes.Fig. “A”21Fig. “B”PART LIST1 GLASS HOLDING PROFILE2 COUNTERSUNK SELF-THREADING SCREWSAINNER FLUSH SURFACEABBOUTER FLUSH SURFACEFig. “C”<strong>Donzelli</strong> S.r.l. Via Bizzozzero, 106 – 20032 Cormano (MI) Tel. +39 02 66301849 Fax +39 02 6152041 info@donzellisrl.com PAGE 13 / 29
Page 1 and 2: ELEVATOR SHAFT MOUNTING INSTRUCTION
Page 11: ELEVATOR SHAFT MOUNTING INSTRUCTION
Page 29: ELEVATOR SHAFT MOUNTING INSTRUCTION

elevator shaft mounting instructions - mod. âlaquilaâ - Donzelli Srl

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

elevator shaft mounting instructions - mod. âlaquilaâ - Donzelli Srl