elevator shaft mounting instructions - mod. âlaquilaâ - Donzelli Srl

More documents

Recommendations

Info

ELEVATOR SHAFT MOUNTING INSTRUCTIONS - MOD. “LAQUILA”Rel. 03 February 2011MILD STEEL ROOF• NOTE: Materials required to perform this stepare supplied in blister pack code “ DZ9F314 -mild steel roof mounting hardware Kit ”245• Referring to the main drawing, determine thedirection of the slope and then mount the front(1) and rear supports (2) as shown in picture“A”• Install the crossbars (3) by the mean of theproper M10 screws and bolts3• Set the top cover sheet (4) and secure it inplace by the mean of the specific self tappingscrews and licking-proof washers• Repeat the above mentioned step to set theother top cover sheet (5)1Fig. “A”ABPART LIST1 FRONT SUPPORTING PLATE2 REAR SUPPORTING PLATE3 CROSSBARS4 TOP COVER SHEET5 TOP COVER SHEETFig. “B”ABFLAT (SLOPED) VERSIONDOUBLE RIDGE VERSIONDonzelli S.r.l. Via Bizzozzero, 106 – 20032 Cormano (MI) Tel. +39 02 66301849 Fax +39 02 6152041 info@donzellisrl.com PAGE 26 / 29
ELEVATOR SHAFT MOUNTING INSTRUCTIONS - MOD. “LAQUILA”Rel. 03 February 2011LANDING DOOR SIDE PANELS1• NOTE: Materials required to perform this stepare supplied in blister pack code “DZ9F224 –Landing door side panels Kit”Picture “A”423Picture “B”• NOTE: The side panels are supplied withholes to make installation easier. Only selfthreadingscrews are required for all fasteningoperations on to the structure.• Position the top panel (if present) inside thelintel as shown on Picture “A” and fasten it tothe structure as shown on Picture “C”.• Position the side panels as shown on picture“A” and fasten them to the structure as shownon picture “B”.• NOTE: The size and finish of the panels varybased on the design specifications. To definethe position for assembly, please refer to theproject drawing.• IMPORTANT: The side panels are justaesthetical components, not load bearingelements. Therefore we recommend fasteningthe floor door frame to the upper and lowercrossbars.PART LIST1 TOP PANEL2 LEFT PANEL3 RIGHT PANEL4 COUNTERSUNK SELF-THREADING SCREWSPicture “C”Donzelli S.r.l. Via Bizzozzero, 106 – 20032 Cormano (MI) Tel. +39 02 66301849 Fax +39 02 6152041 info@donzellisrl.com PAGE 27 / 29
Page 1 and 2: ELEVATOR SHAFT MOUNTING INSTRUCTION
Page 25: ELEVATOR SHAFT MOUNTING INSTRUCTION
Page 29: ELEVATOR SHAFT MOUNTING INSTRUCTION

elevator shaft mounting instructions - mod. âlaquilaâ - Donzelli Srl

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

elevator shaft mounting instructions - mod. âlaquilaâ - Donzelli Srl