elevator shaft mounting instructions - mod. “laquila” - Donzelli Srl

ELEVATOR SHAFT MOUNTING INSTRUCTIONS - MOD. “LAQUILA”Rel. 03 February 2011HEADER BRACINGCROSS-BARS• NOTE: Materials required to perform this stepare supplied in box “DZ9F222 - HeaderCross-Bar Kit”• Position the eye screws (1) as shown in thepictures• Measure the diagonal distance between theeye screws to determine the length of thethreaded rods required and cut them to size.• Slide the threaded rod through the hole of theeye screw as indicated in Picture “A” andfasten it using the required bolts.• Adjust the tension of the threaded rods andthen lock them tightening the nut.Picture “A”Picture “B”• NOTE: Header cross-bar is supplied only ifrequired (refer to the technical calculationreport for details) or upon request.231• NOTE: If headroom service crossbar ispresent, mount the crossbars upside down(with eye screw facing upward)• IMPORTANT: Using a header bracingcrossbar reduces by approx 30mm theheadroom324PART LIST1 M10 EYE SCREW2 M10 HEX NUT3 Ø10,2 FLAT WASHER4 M12 X 3000 THREADED RODPicture “C”Donzelli S.r.l. Via Bizzozzero, 106 – 20032 Cormano (MI) Tel. +39 02 66301849 Fax +39 02 6152041 info@donzellisrl.com PAGE 20 / 29