elevator shaft mounting instructions - mod. âlaquilaâ - Donzelli Srl
elevator shaft mounting instructions - mod. âlaquilaâ - Donzelli Srl
elevator shaft mounting instructions - mod. âlaquilaâ - Donzelli Srl
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
ELEVATOR SHAFT MOUNTING INSTRUCTIONS - MOD. “LAQUILA”Rel. 03 February 20111FIXINGS - STRUTS• NOTE: Materials required to perform this stepare supplied in box “DZ9FXXX – Crossbarsfixings Kit”32• Drill a Ø 15mm hole on the crossbar asshown on picture “A”• Drill a Ø 15 x 100mm hole onto the wallcoaxial to the one shown above• Cut the pipe (2) to the desired lenght54• Depending on the type of the wall, apply theresin (1) as shown on the charts at the bottomof the page• Mount the threaded rod (3) tightening the nut(5) locking the pipe between the wall and thesteel structurePicture “A”CODE L (mm) RANGE (mm)XXX 200 da 0 a 200XXX 500 200 0 a 500XXX 1000 da 500 a 1000XXX 1500 da 1000 a 1500IMPORTANT: Unless otherwise stated, at least 3uprights must be connected to a structuralelement (e.g. building’s wall), at a distance notgreater than 3,5mt among them. Pit andheadroom of the structure must also be securelyfastened onto the buildingELENCO COMPONENTI1 CHEMICAL ANCHOR M12 (NOT SUPPLIED)2 Ø 30mm STEEL PIPE3 THREADED ROD M124 Ø12,2 FLAT WASHER5 M12 HEX NUTANCHORING ONTO STONE WALLS,CONCRETE AND BRICK WALLSANCHORING ONTO CAVITY BRICK WALLS<strong>Donzelli</strong> S.r.l. Via Bizzozzero, 106 – 20032 Cormano (MI) Tel. +39 02 66301849 Fax +39 02 6152041 info@donzellisrl.com PAGE 22 / 29