SDIKTM ProcessControl2TM Setup Guide - FishmanÂ® Corporation

More documents

Recommendations

Info

6. LDS Push-to-Connect Gun Assembly6.1 The LDS Push-to-Connect dispense gunare available in differentconfigurations.• LDAV (Large DotAny Viscosity)• MDAV (Medium DotAny Viscosity• SDAV (Small DotAny Viscosity)The gun connectorsare identical for easyhook-up to the LDSPush-to-Connectdispense gun.SurLokRetainingRing CoverGeniusTip CapGenius SyringeGenius PosilokPistonPiston HubLead ScrewLDAV, MDAVor SDAV GunFishman <strong>Corporation</strong> USA Toll Free 1-800-433-211514 Fishman <strong>Corporation</strong> USA Toll Free 1-800-433-2115
7.0 Attach the Genius Syringeto LDS Push-to-Connect Dispense Gun7.1 Verify the AUTO(Manual) button isset to MANUAL(Auto). Verify theEXTEND(Retract) button is set toEXTEND(Retract).Note: Gun is shipped fully retracted, however if gunhas been used before this setup that may no longerbe the case. Verify this by selecting MANUAL(Auto)and RETRACT(Extend), pressing finger switch untillead screw stops.MANUAL(Auto)EXTEND(Retract)International +00 1 508-435-2115 www.fishmancorp.com 15
Page 2: 3 Fishman Corporation USA Toll Free
Page 7 and 8: 4. Hook up your SmartDispenser Inte
Page 9 and 10: 5. Startup and Logon theProcessCont
Page 11 and 12: 5.3 The system software will now be
Page 13: 5.7 On SmartDispenser Integration K
Page 17 and 18: CAUTION:Do not over-tighten the syr
Page 19 and 20: 8.4 If too much fluid: On thecontro
Page 22 and 23: 9C Anatomy9D Dot AnatomyLengthDWidt
Page 24 and 25: 9.5 Click Dispense Volume (cc) and
Page 26 and 27: 9.16 Press the finger switch as man
Page 28 and 29: 9.30 Repeat 9.19 - 9.29 as many tim
Page 30 and 31: 11.0 Clear SavedProcessControl 2 Pr
Page 32: Fishman Corporation192 South Street

SDIKTM ProcessControl2TM Setup Guide - FishmanÂ® Corporation

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?