2009 Maxima Owner's Manual

Rear-facing – step 1
Rear-facing
WRS0256
Follow these steps to install a rear-facing child
restraint using the vehicle seat belt in the rear
seats:
1. Child restraints for infants must be
used in the rear-facing direction and
therefore must not be used in the front
seat. Always follow the restraint manufacturer’s
instructions.
WRS0682
Rear-facing – step 2
2 Route the seat belt tongue through the child
restraint and insert it into the buckle �2 until
you hear and feel the latch engage. Be sure
to follow the child restraint manufacturer’s
instructions for belt routing.
�
LRS0669
Rear-facing – step 3
3. Pull the shoulder belt until the belt is fully
extended. At this time, the seat belt retractor
is in the Automatic Locking Retractor (ALR)
mode (child restraint mode). It reverts to
Emergency Locking Retractor (ELR) mode
when the seat belt is fully retracted.
Safety—Seats, seat belts and supplemental restraint system 1-29