Geared motors

+8200 motec automationFieldbus function modulesPROFIBUS-DPPROFIBUS-DP Order no. E82ZAFPC001The PROFIBUS-DP fieldbus function module is a slaveinterface module with the PROFIBUS-DPprofile.It is used for networking between hostsand the 8200 motec.Terminal assignmentX3/ Designation Function Level PES Additional HF shield terminationA T/R(A) RS485 data line AB T/R(B) RS485 data line BCN CNTR See PROFIBUS-DP standard 1) For data transmission:CNTR = HIGH(+5 V, reference: GND3)VP See PROFIBUS-DP standard 1) +5 V (reference: GND3)40 GND3 Reference potential for PROFIBUS-DP network 1)7 GND1 Reference potential for X3/2039 GND2 Reference potential, controller inhibit (CINH) on X3/2828 CINH Controller inhibit • Start = HIGH (+12 V … +30 V)• Stop = LOW (0 … +3 V)20 DC voltage source for internal +20 V (reference: GND1)supply for controller inhibit (CINH)59 External DC supply for function module U(ext.) = +24 V DC ±10%(reference: GND1)1) e.g. connection of a repeaterSupply for controller inhibit (CINH) via internal voltage source(X3/20)Supply for controller inhibit (CINH) via externalvoltage sourceX3GND1GND1GND3 GND2+5V +20VA B CN VP A B 40 7 39 28 20 59 7X3GND1GND1GND3 GND2+5V +20VA B CN VP A B 40 7 39 28 20 59 7_T/R(A) T/R(B)T/R(A) T/R(B)T/R(A) T/R(B)T/R(A) T/R(B)+Supply for function module and controller inhibit(CINH) via external voltage source9X3GND1GND1GND3 GND2+5V +20VA B CN VP A B 40 7 39 28 20 59 7__T/R(A) T/R(B)T/R(A) T/R(B)+Minimum wiring required for operation9-42 G-motion motec en 11/2004