Geared motors

8200 motec automationFieldbus function modulesAS-InterfaceGeneral data and operating conditionsProtocol/Communication mediumAS-iNetwork topologyTreeNodeSlaveMax. no. of nodes 31Baud rate [kbps] 167Cycle time [ms]5 ms (31 nodes)Max. bus length [m] 100Electrical connection (terminal strip X3)Screw terminalsDigital inputs 2Connection options (terminal strip X3.2) Rigid: 1.5 mm 2 (AWG 16)Flexible:1.0 mm 2 (AWG 18) without wire end ferrule0.5 mm 2 (AWG 20) with wire end ferrule without plastic sleeve0.5 mm 2 (AWG 20) with wire end ferrule and plastic sleeveConnection options (terminal strip X3.1)1.5 mm 2 (AWG 16) with wire end ferrule and plastic sleeveDC voltage supply for function moduleVia the busInsulation voltage to reference earth/PE50 V ACAmbient temperature Operation: –20 ... +60°CTransport: –25 ... +70°CStorage: –25 ... +60°CClimatic conditions Class 3K3 to EN 50178(without condensation, average relative humidity 85%)Function module E82ZAFFC001The following are available:• 4 AS-i data bits to the 8200 motec (control)The bits can be freely assigned in the 8200 motec.Example:– Bit 1 assigned with function "Fixed setpoint 1"– Bit 2 assigned with function "Fixed setpoint 2"– Bit 3 assigned with function "DC injection brake"– Bit 4 assigned with function "Reversal of rotation direction"˘ 1 AS-i data bit from the 8200 motec (feedback)The bit can be freely assigned in the 8200 motec, e.g. withtrip error message.˘ 1 AS-i monitoring bit from the AS-i module˘ 2 data bits digital inputs of the moduleNote: The function module features two communication status LEDs.Wiring the AS-i networkWiring can be completed quickly and easily using an AS-iflat-cable connection (type E82ZMFF). The cables are securedin a cable entry in the carrier housing (M16).9AS-i flat-cable connection (type E82ZMFF)G-motion motec en 11/20049-49