Users instructions FM+DEX - Widex for professionals

More documents

Recommendations

Info

Regulatory informationFCC ID: TTY-FMDIC: 5676B-FMDFederal Communications Commission StatementThis device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) this device must accept any interference received,including interference that may cause undesired operation.NOTE:This equipment has been tested and found to complywith the limits for a Class B digital device, pursuantto part 15 of the FCC Rules. These limits are designedto provide reasonable protection against harmfulinterference in a residential installation. This equipmentgenerates, uses and can radiate radio frequency energyand, if not installed and used in accordance with theinstructions, may cause harmful interference to radiocommunications. However, there is no guarantee thatinterference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radioor television reception, which can be determined byturning the equipment off and on, the user is encouragedto try to correct the interference by one or more of thefollowing measures:36
— Reorient or relocate the receiving antenna.— Increase the separation between the equipment andreceiver.— Connect the equipment into an outlet on a circuitdifferent from that to which the receiver is connected.— Consult the dealer or an experienced radio/TVtechnician for help.NOTE:This equipment complies with FCC radiation exposurelimits set forth for an uncontrolled environment. Thistransmitter must not be co-located or operating inconjunction with any other antenna or transmitter.Changes or modifications to the equipment not expresslyapproved by Widex could void the user’s authority tooperate the equipment.Industry Canada Statement /Déclaration d’industrie CanadaUnder Industry Canada regulations, this radio transmittermay only operate using an antenna of a type andmaximum (or lesser) gain approved for the transmitter byIndustry Canada.To reduce potential radio interference to other users, theantenna type and its gain should be so chosen that theequivalent isotropically radiated power (e.i.r.p.) is notmore than that necessary for successful communication.This device complies with Industry Canada licenceexemptRSS standard(s). Operation is subject to thefollowing two conditions:37
Page 1 and 2: User instructionsFM+DEX
Page 3 and 4: Contentssymbols ...................
Page 5 and 6: Your new FM+DEXYour FM+DEX is part
Page 7 and 8: FM+DEX OVERVIEW1. On/Off2. Input to
Page 9 and 10: OPERATING RANGESFrom FM+DEX to hear
Page 11 and 12: 1. Connect the charger to the mini
Page 13 and 14: FMIf you wish to listen to an FM so
Page 15 and 16: 5. Attach the cover again.Pressing
Page 17 and 18: AntennaThe FM+DEX can be used with
Page 19 and 20: An alternative way of using the dev
Page 21 and 22: To open the clip, click the lock op
Page 23 and 24: TURNING ON THE devicePush the slide
Page 25 and 26: Selecting input sourceThe device st
Page 27 and 28: Room offIf you wish to listen to th
Page 29 and 30: Tamper switchThe input toggle/room
Page 31 and 32: Problem Possible cause SolutionThe
Page 33 and 34: CARING FOR YOUR FM+DEXThe device is
Page 35: Safety WarningThis device is charge
Page 39 and 40: Hereby, Widex A/S declares that thi
Page 44: ManufacturerPrinted by HTO / 2012-0

Users instructions FM+DEX - Widex for professionals

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?