Instruction Manual book - Pichler

More documents

Recommendations

Info

EDGE 540 V3-30cc - Item code: BH94 .Instruction ManualVERTICAL INSTALLATION.Vertical stabilizer installationSee picture below. 4. Now, remove the rudder and using amodeling knife, carefully cut just inside themarked lines and remove the film of the rudder.Just as you did with the horizontal stabilizer,make sure you only press hard enoughto cut the film, not the balsa rudder. Also carefully remove the covering fromthe horizontal fin as below the lines whichyou drew as same picture below.Removecovering.Removecovering. 1. Put the rudder into the fuselage as sameas picture below. 2. Mark the shape of the vertical on theleft and right side of the rudder on to the horizontalstabilizer using a felt-tip pen. 5) When you are sure that everything is aaligned correctly, mix up a generous amountof 30 minute epoxy. Apply a thin layer to theslot in the mounting platform and to the verticalstabilizer mounting area. Apply epoxy tothe lower rudder hinge. Set the stabilizer inplace and re-align. Double check all of yourmeasurements once more before the epoxycures. Remove any excess epoxy using apaper towel and rubbing alcohol and hold thestabilizer in place with T-pins or masking tape.Allow the epoxy to fully cure before proceeding.Mark line.HorizontalStabilizer.90ºVerticalStabilizer.16
EDGE 540 V3-30cc - Item code: BH94 .Instruction ManualSecureEpoxy glue.Epoxy glue.4 x 50mmC/A glue.Secure.4x 50mmELEVATOR CONTROL HORN INSTALLA-TION.SecureElevator control horn install as same as theway of aileron control horn. Please see picturesbelow.3 x 40 mm.M2 lock nut.17
Page 5 and 6: EDGE 540 V3-30cc - Item code: BH94
Page 15: EDGE 540 V3-30cc - Item code: BH94
Page 27: EDGE 540 V3-30cc - Item code: BH94

Instruction Manual book - Pichler

Create successful ePaper yourself

Delete template?

Save as template?