Fybroc Division series 1500 horizontal pumps - MHz Electronics, Inc

MAXIMUM ALLOWABLE MISALIGNMENTSleeve Type JE & JN Type E & N Type HSize Parallel Angular Parallel Angular Parallel Angular3 .010 .035 — — — —4 .010 .043 — — — —5 .015 .056 .015 .056 — —6 .015 .070 .015 .070 .010 .0167 .020 .081 .020 .081 .012 .0208 .020 .094 .020 .094 .015 .0259 — — .025 .109 .017 .02810 — — .025 .128 .020 .03211 — — .032 .151 .022 .03712 — — .032 .175 .025 .04213 — — .040 .195 — —14 — — .045 .242 — —16 — — .062 .330 — —(Dimensions in Inches)10) If the coupling employs a two-piece sleevewith the wire ring, force the ring into itsgroove in the center of the sleeve. It may benecessary to pry the ring into position with ablunt screwdriver.11) Install the coupling guard over the couplingassembly and finger tighten the coupling guardcap-screws. Check for any contact betweenthe guard and the rotating assembly. Thentighten the coupling guard bolts to the torquevalues given on the side of the baseplate.WARNING: DO NOT OPERATE THE PUMPWITHOUT THE COUPLING GUARDINSTALLED PROPERLY AS COUPLINGSLEEVES CAN BE THROWN FROM THECOUPLING ASSEMBLY WITH SUBSTAN-TIAL FORCE IF THE COUPLING IS SUB-JECTED TO A SEVERE SHOCK LOAD.12) To remove the sleeve for inspection orreplacement, remove the eight cap-screwsfrom the spacer hubs. Then loosen the hubset-screws and slide the hubs back and dropthe sleeve and flange assembly out.WARNING: NEVER REPLACE A HYTRELSLEEVE WITH A RUBBER SLEEVE ASTHESE SLEEVES HAVE COMPLETELYDIFFERENT RATINGS AND INTERCHANG-ING THEM CAUSE DAMAGE TO THEEQUIPMENT.18