1964-65 chevrolet chevelle/ el camino - Classic Auto Air

More documents

Recommendations

Info

YOU CAN NOW BEGIN THE INSTALLATION Remove Glove box door and glove box, discard glove box retain original hardware. One attached to the Heat / defrost door. This can be found behind heater box next to the throttle cable. Removal of Original Heater Assembly can be accomplished by disconnecting the three control cables. One attached to the Temperature door. The third cable is located on top of heater next to the defrost ducts. 4
Remove (4) screws located under the control head. Remove the control head and set aside for modification and reinstall. Disconnect electrical harness at the resistor block. 2 SCREWS 2 SCREWS In order to remove the heater assembly it is necessary to remove the Blower Housing Assembly first. Carefully lift vehicle and place support stands under center of the vehicle as shown. It is necessary to lower the inner fender well on the passenger side. Remove the passenger front tire. Remove and retain (9) bolts from around the inner fender. Lower the inner fender well to gain access to (2) screws above and below the blower motor assembly. 5
Page 1 and 2: specializing in “AIR CONDITIONING
Page 3: specializing in “AIR CONDITIONING
Page 7 and 8: Heater hoses Remove heater assembly
Page 9 and 10: Locate behind control opening the o
Page 11 and 12: Locate refrigeration tape provided
Page 14 and 15: Connect power wire (brown / from th
Page 16 and 17: Install glove box and the glove box
Page 18 and 19: DISCHARE TUBE Attach discharge tube
Page 20: IMPORTANT CAUTION: WATER VALVE MUST

1964-65 chevrolet chevelle/ el camino - Classic Auto Air

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?