installation instructions and wiring for p/n 8715 ... - Faraday

8715 ADDRESSABLE AUDIBLE BASETO NEXTADDRESSABLEDEVICELINE 1 LINE 2TO NEXT 8715 OR PROPEREND OF LINE RESISTOR(SEE NAC INSTALLATIONINSTRUCTIONS)567887154321JUMPER FORTONE SELECTIONLINE 1 LINE 2FROM ADDRESSABLE DEVICE CIRCUITOF A COMPATIBLE CONTROL UNIT ORPREVIOUS ADDRESSABLE DEVICENOTES:1. For temporal tone, jumper terminals 3 and 4 as shown.For steady tone, do not jumper terminals 3 and 4.2. Audible Base electrical ratings:Alarm voltage range: 17-31VDCSupervisory current: 0mAAlarm current:24mA @ 25VDC3. T-tapping of notification appliance circuits is not allowed.FROM NOTIFICATION APPLIANCE CIRCUITOF A COMPATIBLE CONTROL UNIT OR8706 ADDRESSABLE NAC MODULE(POLARITY SHOWN IN ALARM)+4. Terminals 5-8 of the 8715 are polarity insensitive. Line 1and Line 2 can be either line of the loop.5. The 8715 shown can be wired as Style Z (Class A) orStyle Y (Class B). Refer to the installation instructions forthe addressable device circuit and NAC circuit asapplicable.6. Polarity shown in alarm at terminals 1 and 2 of the 8715.Each audible base must be tested to verify operation._Figure 28715 Wiring8716 ADDRESSABLE RELAY BASELINE 1LINE 1TO NEXT DEVICEDO NOT USE AN ENDOF LINE DEVICEFROM ADDRESSABLE DEVICECIRCUIT OF A COMPATIBLECONTROL UNIT OR PREVIOUSADDRESSABLE DEVICE87165NOC6NCRELAY CONTACTS3A, 120 VAC3A, 30 VDCRESISTIVELINE 2NOTE: RELAY CONTACTS ARE SHOWN IN THE SYSTEM NORMAL CONDITION.LINE 1 AND LINE 2 CAN BE EITHER LINE OF THE LOOP.LINE 2TO NEXT DEVICEDO NOT USE AN ENDOF LINE DEVICEFigure 38716 WiringPAGE 2 OF 2P/N 315-033220FA -2