FA-M3 Hardware Manual - Yokogawa

A2-14CAUTIONLG terminal has a half potential of the input power supply voltage when LG terminal isn’tconnected to FG terminal.• Terminal dimensionsF3PU10-0N / F3PU20-0NM3.5F3PU10-0S / F3PU20-0SM47.1mm8.2mm7.1mm8.2mmFA020304.VSD• Adaptable crimp-on terminalVendor Model Compatible ConductorJapan SolderlessTerminal Mfg Co., Ltd.Nippon Tanshi Co., Ltd.Japan SolderlessTerminal Mfg Co., Ltd.Japan SolderlessTerminal Mfg Co., Ltd.V1.25-M3RAV1.25-3.5V1.25-M4V2-M4AWG22 to 18(0.33 to 0.82 mm 2 )(Copper wire)AWG16 to 14(1.3 to 2.1 mm 2 )(Copper wire)Compatible Modules andCrimping TorqueF3PU10-0N F3PU10-0SF3PU20-0N F3PU20-0S0.8 N⋅m(7.1 lbf⋅in)May not beused1.2 N⋅m(10.6 lbf⋅in)CAUTIONWhen crimping terminals, be sure only to use the tool specified by each terminalmanufacturer.Once the power supply module is installed in the base module, both the FG terminal ofthe power supply module and the signal ground (GND terminal of the module’s 5 Voutput) of the FA-M3 automatically come into contact with the metal chassis of the basemodule. The FG terminal and the signal ground are isolated from each other inside thepower supply module.For details on the grounding lines of the FA-M3, see subsection A3.3.2, “GroundingLines.”CAUTION- F3PU10-0N (respectively F3PU20-0N) and F3PU10-0S (respectively F3PU20-0S)have the same dimensions, internal circuitry and other characteristics, except thatF3PU10-0N (respectively F3PU20-0N) uses M3.5-screw terminals while F3PU10-0S(respectively F3PU20-0S) uses M4-screw terminals.- F3PU10-0N and F3PU20-0N are not CE Marking compliant.F3PU10-0S and F3PU20-0S are CE Marking compliant.- For compliance to CE Marking of the final product incorporating these modules,F3PU10-0S or F3PU20-0S must be used.IM 34M06C11-01E 23nd Edition : Oct. 01, 2013-00