Micro MATE-N-LOK Connectors - Logic IO

Micro MATE–N–LOK Connectors114–13000NOTE: Receptacle contact shown, plug contact has same dimensions for crimp requirements.Transition Area (WireInsulation and ConductorsMust Be Visible Here)1.80 Min EffectiveCrimp LengthInsulation Barrel MustGrasp Wire InsulationInsulation Does NotEnter Wire BarrelNo Wire StrandsShows in WireBarrel SeamNo Damage toSpring Members0.13 Min RearBellmouthA0.13 MaxFront Bellmouth0.56–0.69Locking LanceHeight0.25 MaxRear Cutoff Tab (SeeDetail A)Insulation Barrel(“F” Crimp)OrientationBarrelAWire ConductorEnds Flush to orExtends 1.58 (Max)Beyond Wire BarrelWire Barrel CrimpWidth (See Table)Section A–ANo Damage or DistortionPermitted in This Area0.13 MaxBurr Allowance0.11 MaxFront Cutoff Tab(See Detail B)Detail AWire Barrel(“F” Crimp)0.20 Max WireBarrel FlashWire Barrel CrimpHeight (See Table)Detail B0.13 MaxBurr AllowanceNOTE: Locking lance height is different for plug contacts. Refer tothe appropriate customer drawings for specific dimensions.Figure 4NOTEThe developed crimp configurations result from using the specific tooling described in Section 5, TOOLING.M. StraightnessThe force applied during crimping may cause some bending between the wire barrel and the matingportion of the contact. Such deformation is acceptable within the following limits.1. Up and DownThe crimped portion, including cutoff tab and burr, must not be bent beyond the limits shown in Figure 5.2. Side–to–SideThe crimped portion must not be bent from one side to the other beyond the limits shown in Figure 5.6 of 18Rev A