Features of the Jergens Zero Point Mounting System - Jergens Inc.

More documents

Recommendations

Info

ZERO POINT MOUNTING SYSTEMWORKHOLDING SOLUTIONS GROUPMechanical Locking SystemExperience high holding force without the need to maintainhydraulic pressure.Large Ball DiameterProvides increased strength and even load distribution.No Ball CageFree movement of the bearing balls reduces friction.Form Fit Ball ChannelTapered contact areas eliminate point loads andreduce failures.Three-Point Load DistributionQUICK CHANGE FIXTURING » ZERO POINT MOUNTING SYSTEMEqual load spacing optimizes force distribution.Integrated Safety SystemProcess-sure clamping module can always be opened,eliminating the need to forcibly remove modules if a failureshould occur.Phone: 877-426-2504 | Fax: +1 216-481-6193 | E-mail: workholding@jergensinc.com | www.jergensinc.com41
ZERO POINT MOUNTING SYSTEMWORKHOLDING SOLUTIONS GROUPClamping and PositioningOn each fixture use:• 1 – Zero Point Pull Stud• 1 – Timing Pull Stud• The Zero Point and Timing Studshould be perpendicular• Use any combination of clearanceand/or protection Pull StudZERO POINT PULL STUDCLEARANCE PULL STUDFOR HOLD DOWNQUICK CHANGE FIXTURING » ZERO POINT MOUNTING SYSTEMDimensions for machining pull stud mountingsCLEARANCE PULL STUDFOR HOLD DOWNTIMING PULL STUDSize ØD1 ØM S1 S2K5 10 M6 2.5 12K10 15 M8 3.5 16K20 25 M12 5.5 23K40 25 M16 5.5 30Note:• Pull Stud with internal thread for clamping from above• Pull Studs with different diameter D1, preventing interchange of theZero Point, timing and clearance Pull Stud during installation.• Pull Stud for series production, (notch type), Floating Pull Stud forcompensation of thermal expansion• Automatic lifting of the pallet / fixtureFigure:Shown with Pull Stud and engagement screw42Jergens, Inc. | 15700 S. Waterloo Road | Cleveland, Ohio 44110-3898 USA
Page 2 and 3: ZERO POINT MOUNTING SYSTEMWORKHOLDI

Features of the Jergens Zero Point Mounting System - Jergens Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?