3A2308A - Protective Coating Hand-Held Paint Sprayer, Operation ...

OperationInstall Tip/Guard Assembly(if not installed)2. Install liner into material cup and fill with material.NOTE: Only use Graco Tip/Guard assemblies.This equipment stays pressurized until pressure ismanually relieved. To help prevent serious injuryfrom pressurized fluid, such as skin injection,splashing fluid and moving parts, follow thePressure Relief Procedure when you stop sprayingand before cleaning, checking, or servicing theequipment.ti19348a3. Thread lid onto material cup and connect cup tosprayer. NOTE: Do not squeeze sides of cup whilethreading lid onto cup.1. Engage trigger lock and put prime/pressure reliefvalve UP to relieve pressure.ti19354ati19384ati19350ati19347aNOTE: Check valve can be oriented in three locationswhen attached to cup. If squeezing liner withleft hand, position check valve on left side. Ifsqueezing liner with right hand, position check valveon right side.Do NOT place hands in front of tip.2. Screw Tip/Guard Assembly onto sprayer. Tightenretaining nut until completely engaged with sprayer.Do not overtighten nut.ti19355a4. Squeeze liner to purge air through check valve untilmaterial is present at check valve.ti19369aFilling and Installing Cup1. Engage trigger lock and put prime/pressure reliefvalve UP to relieve pressure.ti19350ati19347ati19367aNOTE: To purge the maximum amount of air out ofthe liner, slightly tilt the sprayer so the check valve isthe highest point.14 3A2308A