HP LaserJet M3027/M3035 MFP User Guide - ENWW - Unik

More documents

Recommendations

Info

Table 2-10 Jetdirect menus (continued) Menu item Sub-menu item Sub-menu item Values and Description Ping Results Use this item to view the ping test status and results using the control panel display. You can select the following items: Packets Sent Shows the number of packets (0 - 65535) sent to the remote host since the most recent test was initiated or completed. Packets Received Shows the number of packets (0 - 65535) received from the remote host since the most recent test was initiated or completed. Percent Lost Shows the percent of ping test packets that were sent with no response from the remote host since the most recent test was initiated or completed. RTT Min Shows the minimum detected roundtrip- time (RTT), from 0 to 4096 milliseconds, for packet transmission and response. RTT Max Shows the maximum detected roundtrip- time (RTT), from 0 to 4096 milliseconds, for packet transmission and response. RTT Average Shows the average round-trip-time (RTT), from 0 to 4096 milliseconds, for packet transmission and response. Ping In Progress Shows whether a ping test is in progress. Yes indicates a test in progress, and No indicates that a test completed or was not run. Refresh When viewing the ping test results, this item updates the ping test data with current results. Select Yes to update the data, or No to maintain the existing data. However, a refresh automatically occurs when the menu times out or you manually return to the main menu. Link Speed The link speed and communication mode of the print server must match the network. The available settings depend on the device and installed print server. Select one of the following link configuration settings: CAUTION If you change the link setting, network communications with the print server and network device might be lost. Auto (default): The print server uses auto-negotiation to configure itself with the highest link speed and communication mode allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set depending on the detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.) 10T Half: 10 Mbps, half-duplex operation. 10T Full: 10 Mbps, Full-duplex operation. 100TX Half: 100 Mbps, half-duplex operation. 100TX Full: 100 Mbps, full-duplex operation. 34 Chapter 2 Control panel <strong>ENWW</strong>
Table 2-10 Jetdirect menus (continued) Menu item Sub-menu item Sub-menu item Values and Description 100TX Auto: Limits auto-negotiation to a maximum link speed of 100 Mbps. 1000TX Full: 1000 Mbps, full-duplex operation. Print Protocols Use this item to print a page that lists the configuration of the following protocols: IPX/SPX, Novell NetWare, AppleTalk, DLC/LLC. <strong>ENWW</strong> Use the Administration menu 35
Page 1: HP LaserJet M3027/M3035 MFP User Gu
Page 4 and 5: Copyright and License © 2006 Copyr
Page 6 and 7: Default E-mail Options ............
Page 8 and 9: 7 Copy Print on both sides manually
Page 10 and 11: Clear jams from the ADF ...........
Page 12 and 13: Plastics ..........................
Page 14 and 15: Device comparison HP LaserJet M3027
Page 16 and 17: Walkaround Device parts Before usin
Page 18 and 19: Device software The printing-system
Page 20 and 21: ● Printer Properties dialog box (
Page 22 and 23: ● Assign an internet protocol (IP
Page 24 and 25: 12 Chapter 1 Device basics ENWW
Page 26 and 27: Use the control panel The control p
Page 28 and 29: Buttons on the touchscreen The stat
Page 30 and 31: Information menu Use this menu to p
Page 32 and 33: Default Copy Options NOTE Values sh
Page 34 and 35: Default E-mail Options Use this men
Page 36 and 37: Default Print Options Use this menu
Page 38 and 39: Table 2-7 Time/Scheduling menu (con
Page 40 and 41: Initial Setup menu The Initial Setu
Page 42 and 43: Table 2-10 Jetdirect menus (continu
Page 44 and 45: Table 2-10 Jetdirect menus (continu
Page 48 and 49: Fax Setup Table 2-11 Fax Setup menu
Page 50 and 51: Table 2-11 Fax Setup menu (continue
Page 52 and 53: Device Behavior menu Table 2-14 Dev
Page 54 and 55: Table 2-14 Device Behavior menu (co
Page 56 and 57: Table 2-15 Print Quality menu (cont
Page 58 and 59: Table 2-16 Troubleshooting menu (co
Page 60 and 61: 48 Chapter 2 Control panel ENWW
Page 62 and 63: USB configuration This device suppo
Page 64 and 65: 6. Touch IPV4 Settings. 7. Touch Co
Page 66 and 67: 7. Touch Off. 8. Touch Save. Disabl
Page 68 and 69: General guidelines for media Before
Page 70 and 71: Media considerations Envelopes Enve
Page 72 and 73: CAUTION To avoid damaging the produ
Page 74 and 75: Media type Fuser mode setting Prepr
Page 76 and 77: Manual 2-sided printing. Most of th
Page 78 and 79: Load media Load special print media
Page 80 and 81: 4. Place media into the tray (short
Page 82 and 83: 4. Place the paper in the tray and
Page 84 and 85: Control print jobs When a job is se
Page 86 and 87: Print to the rear output bin NOTE W
Page 88 and 89: Use the convenience stapler A conve
Page 90 and 91: 3. Insert a new staple cartridge in
Page 92 and 93: Print the remaining copies of a pro
Page 94 and 95: Print additional copies of a QuickC
Page 96 and 97:
5. Touch Delete. 6. Touch Yes. If t
Page 98 and 99:
Use features in the Windows printer
Page 100 and 101:
4. On the Custom Paper Size window,
Page 102 and 103:
Use automatic duplex printing 1. In
Page 104 and 105:
Use features in the Macintosh print
Page 106 and 107:
Print on both sides manually 1. Ins
Page 108 and 109:
96 Chapter 6 Print ENWW
Page 110 and 111:
Use the Copy screen From the Home s
Page 112 and 113:
Basic copy instructions This sectio
Page 114 and 115:
Copy two-sided documents Two-sided
Page 116 and 117:
Copy mixed-size originals You can c
Page 118 and 119:
Copy photos and books Copy a photo
Page 120 and 121:
Cancel a copy job To cancel the cop
Page 122 and 123:
Configure e-mail settings Before yo
Page 124 and 125:
Use the Send E-mail screen Use the
Page 126 and 127:
Use the auto-complete function When
Page 128 and 129:
Add e-mail addresses to the local a
Page 130 and 131:
Scan to a folder NOTE This device f
Page 132 and 133:
Analog faxing On the HP LaserJet M3
Page 134 and 135:
122 Chapter 9 Fax ENWW
Page 136 and 137:
Use information pages From the cont
Page 138 and 139:
Configure e-mail alerts NOTE If you
Page 140 and 141:
Section Options Supplies Ordering w
Page 142 and 143:
Embedded Web server sections Tab or
Page 144 and 145:
Use HP Web Jetadmin software HP Web
Page 146 and 147:
Item Description Bonjour Settings P
Page 148 and 149:
NOTE Any damage caused by a non-HP
Page 150 and 151:
3. Remove the new print cartridge f
Page 152 and 153:
Clean the device During the printin
Page 154 and 155:
2. Open the ADF cover. 3. Press the
Page 156 and 157:
Calibrate the scanner Calibrate the
Page 158 and 159:
Problem-solving checklist If you ar
Page 160 and 161:
Step number Verification step Possi
Page 162 and 163:
Solve general device problems Devic
Page 164 and 165:
The device prints, but the text is
Page 166 and 167:
Control-panel messages Table 11-1 C
Page 168 and 169:
Table 11-1 Control-panel messages (
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Jam locations Use this illustration
Page 178 and 179:
Clear jams When clearing jams, be v
Page 180 and 181:
Clear jams from the input-tray area
Page 182 and 183:
2. Open the plate, and then slowly
Page 184 and 185:
Clear jams from the duplexer 1. Rem
Page 186 and 187:
● Clean the device. See Clean the
Page 188 and 189:
3. Clear any loose staples from the
Page 190 and 191:
Solve print-quality problems This s
Page 192 and 193:
NOTE These examples depict letter-s
Page 194 and 195:
Gray background 1. Do not use media
Page 196 and 197:
This type of defect might occur whe
Page 198 and 199:
Vertical white lines 1. Print a few
Page 200 and 201:
Random image repetition If an image
Page 202 and 203:
Solve copy problems Prevent copy pr
Page 204 and 205:
Problem Cause Solution Problems wit
Page 206 and 207:
Solve fax problems NOTE For more in
Page 208 and 209:
Faxes are transmitting or being rec
Page 210 and 211:
Solve common Windows problems Error
Page 212 and 213:
The printer driver does not automat
Page 214 and 215:
Solve PostScript problems The follo
Page 216 and 217:
Order parts, accessories, and suppl
Page 218 and 219:
Stapler accessories Item Descriptio
Page 220 and 221:
Item Description Part number HP Off
Page 222 and 223:
(INCLUDING LOST PROFIT OR DATA), OR
Page 224 and 225:
HP Customer Care Online Services Fo
Page 226 and 227:
HP maintenance agreements HP has se
Page 228 and 229:
216 Appendix B Service and support
Page 230 and 231:
Physical specifications Table C-1 P
Page 232 and 233:
220 Appendix C Specifications ENWW
Page 234 and 235:
FCC regulations This equipment has
Page 236 and 237:
you. Your empty HP LaserJet print c
Page 238 and 239:
● HP’s environmental management
Page 240 and 241:
Declaration of conformity Declarati
Page 242 and 243:
EMI statement (Taiwan) Laser statem
Page 244 and 245:
Overview One dual inline memory mod
Page 246 and 247:
3. Remove the right side panel by s
Page 248 and 249:
8. Close the access door, and press
Page 250 and 251:
Enable memory for Windows 1. On the
Page 252 and 253:
4. Connect the network cable to the
Page 254 and 255:
IP address The unique number assign
Page 256 and 257:
EconoMode 135 features 3 genuine HP
Page 258 and 259:
LDAP errors 160 LDAP support 110 lo
Page 260 and 261:
default size 41 default size, selec
Page 262 and 263:
Linux 201 Macintosh issues 199 medi
Page 264 and 265:
support embedded Web server links 1
Page 266:
254 Index ENWW
show all

HP LaserJet M3027/M3035 MFP User Guide - ENWW - Unik

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?