HP LaserJet M3027/M3035 MFP User Guide - ENWW - Unik

Network configuration
You might need to configure certain network parameters on the device. You can configure these
parameters in the following locations:
● Installation software
● Device control panel
● Embedded Web server
● Management software (HP Web Jetadmin or HP LaserJet Utility for Macintosh)
NOTE For more information about using the embedded Web server, see Use the embedded
Web server
For more information on supported networks and network configuration tools, see the HP Jetdirect Print
Server Administrator’s Guide. The guide comes with printers in which an HP Jetdirect print server is
installed.
This section contains the following information about configuring network parameters:
● Configure TCP/IPv4 parameters
● Configure TCP/IPv6 parameters
● Disable network protocols (optional)
● HP Jetdirect EIO print servers
Configure TCP/IPv4 parameters
If your network doesn't provide automatic IP addressing through DHCP, BOOTP, RARP, or another
method, you might need to enter the following parameters manually before you can print over the
network:
● IP address (4 bytes)
● Subnet mask (4 bytes)
● Default gateway (4 bytes)
Set an IP address
You can view the current IP address of the device from the control-panel Home screen by touching
Network Address.
Use the following procedure to change the IP address manually.
1. Scroll to and touch Administration.
2. Scroll to and touch Initial Setup.
3. Touch Networking and I/O.
4. Touch Embedded Jetdirect.
5. Touch TCP/IP.
ENWW Network configuration 51