TECHNICAL MANUAL - Tyrolia

pict 85
Lubricate the new inserts with HEAD/TYROLIA grease, clean
the heel track, and slide the heel back into the track. Lock
the locking lever into the same position it was before.
FOR MOST RAILFLEX AND ALL RAILFLEX LITE HEELS
Use 162 801 for RAILFLEX and 162 725 for RAILFLEX LITE.
Remove the center screw and slide the binding off.
Separate the heel from the Railflex band and turn the heel
around. Remove the inserts and replace them with new
ones (pict 86).
pict 86
SPARE PART IDENTIFICATION
Most of the replaceable parts have an article number (000
000) imprinted on the bottom. Reference this number when
you order spare parts to prevent confusion.
LONG & SHORT SCREWS
Junior Bindings (DIN 7 or 7.5) are delivered with screws
for ski lengths under 140 cm (penetration depth 6 mm).
If they are mounted on longer skis, the screws have to be
replaced with longer screws. (penetration depth 8 mm –
see screw chart on page 30).
TAPPING
HEAD/TYROLIA recommends tapping the drilled binding
holes of any ski before mounting. Of course, there is a
never-ending discussion among the mechanics if this is
really necessary. But the pros are convincing:
• smooth and easy mounting
• reduced risk of stripping a screw
• same momentum adjustment of the screwdriver regard
less of the ski material
• increased mounting quality/precision
• fewer pull outs.
64 / SERVICE
TEMPLATE „ADAPTER SET“
(art. no. 162 569)
Compatible to all TYROLIA-Templates.
WARNING: Avoid dropping of the template. The clamping
jaws could be damaged.
59-108 mm
SKI
For children skis.
1
3
50-99 mm
SKI
For skis with integrated our mounted plates.
For wide skis.
2 83-132 mm
SKI
45-94 mm
SKI
1
2
3