An Exercise in Freezing Point Depression

More documents

Recommendations

Info

Data Sheet III: Determination of the Enthalpy of Solution of a SaltDeicer: Formula _______________________ Molar Mass ________________________Estimated grams of compound that will dissolve in 10 mL of water at 25°C: _____________gTrial 1 Trial 21. Volume of H 2O used ________ mL ________ mL2. Mass of water used ________ g ________ g3. Mass of sample used ________ g ________ g4. Initial temperature of water ________ °C ________ °C5. Final temperature of solution ________ °C ________ °C6. q soln________ J ________ J7. Enthalpy of solution per gram ________ J/g ________ J/g8. Enthalpy of solution in kJ/mol ________ kJ/mol ________ kJ/mol9. Average value of the enthalpy of solution ________ kJ/molShow a complete calculation of the enthalpy of solution below:10-20
Name ___________________________________________ Date ____________________Partner __________________________________________ TA _____________________Post-Laboratory Questions for Experiment 101. Data Treatment for Part 1a) Carry out the necessary calculations and complete the last table on Data Sheet I.b) Prepare a graph for plotting ∆T vs. molality, m for trials 0 through 4 or 5. Selecta scale such that the graph fills over half of a page. Give the graph a title andlabel the axes. (Whether the graph is done by hand or using the computer, anymissing information will result in a loss of all points for b).c) Graph your 5 or 6 data points, including DI water, and draw the best straightline through the data points. The formula for your straight line is ∆T = imK f.(An error in graphing your data points or in drawing the best straight line willresult in the loss of all points for c).d) Determine the slope of ( i x K f) and calculate “i”. Compare this to thetheoretical value of “i”. For example, we expect i ≤ 3 for MgCl 2. Show yourwork.2. Summary of ResultsUse the computer to prepare a table that summarizes the experimental results and anyother information available to your lab section on the 5 deicers. For each deicer,include as much of the following information as possible. “Average values” may referto the average of several trials, as is the case for ∆H soln, or, as in the case of ratingsurface damage, take the average of the ratings assigned by each of the groups. Youneed to submit only one table per group.a) Slope of the plot of ∆T vs molality.b) Value of “i”c) Average mass of ice melted per gram of deicerd) Solubility at 0 or 20°C (g/100 g solvent)e) Average ∆H solnin kJ/molf) Average rating of the surface damage (corrosion or scaling) of the concretesurfaces, iron bars, and iron nails10-21
Page 4: Week One: Gathering DataYour TA wil
Page 9 and 10: Part III: Determining the Enthalpy
Page 11 and 12: Part B. Determination of ∆H solnf
Page 13 and 14: Name: _____________________________
Page 15 and 16: Name: _____________________________
Page 17 and 18: Name: _____________________________
Page 19: Name ______________________________
Page 23: Name: _____________________________

An Exercise in Freezing Point Depression

Create successful ePaper yourself

Delete template?

Save as template?