238T Installation Manual

FIXED HIGH EAVE DETAILMT-25: HIGH EAVETRIM43D POP RIVETS(@ 0'-6" O.C.)3/32" X 1" ROLL TAPESEALANT (CONT. ALONG TOPOF STANDARD OFFSET CLEAT)1/4-14 X 7/8" LAP TEKFASTENERS (@ 1'-0" O.C.)MT-156: RAKE SUPPORT CLEATMT-38: STANDARD OFFSET CLEAT3/32" X 1" ROLL TAPE SEALANT(FILL ANY VOIDS WITH BUTYL TUBESEALANT)OUTSIDE CLOSURE W/3/16" DIA. BEAD OF URETHANESEALANT (BOTTOM AND SIDES)FIELD FOLD PAN OFPANELFASCIA BOARD(NOT BY MCELROY)238T ROOF PANEL238T CLIP#14-10 X 1 1/2" TYPE AFASTENERS (2 PER CLIP)#30 PAPER FELT(NOT BY MCELROY)PLYWOOD DECK(NOT BY MCELROY)MT-156: RAKESUPPORT CLEATMT-38: STANDARDOFFSET CLEATMT-25: HIGH EAVE TRIMNOTES: 1. MT-25 (High Eave Trim), MT-156 (Rake Support Cleat) and MT-38 (Standard Offset Cleat) to runfrom out to out of building.2. Attach MT-156 (Rake Support Cleat) to fascia board with #10-12 x 1" Type A Pancake Head Fastenersat 1'-0" O.C.3. Apply a 3/16" Dia. bead of Urethane Sealant to the pan and up the vertical legs of the panel wherethe Foam Outside Closure will be placed. Install Metal Closure Cover over Foam Outside Closure andattach to panels and clip with (2) 1/4-14 x 1 1/4" HWH Tek2 or ZAC Fasteners to provide a fixed point.Attach 1/4" Offset Cleat to Outside Closures with 1/4-14 x 7/8" Lap Tek fasteners at 1'-0" O.C.4. Apply a continuous line of 3/32" x 1" Roll Tape Sealant to the top flange of the MT-38 (Standard OffsetCleat).5. High Eave Flashing to lap 2". Apply 3/32" x 3/8" Butyl Tape or Butyl Tube Sealant in trim laps andPop Rivet flashing. Offset Cleat will butt joint.C-6