POE-D10-00-E-11-X1Y1Y5P Y5U Y5V CH SL

POE-D10-00-E-12SAFETY STANDARDS REGULATED, REINFORCEDINSULATION TYPE, AH SERIESVer: 12 Page: 12 / 18No Items Performance Testing methodAppearance No marked defect.7.3.127.3.13Humidity(Under steadyState)HumidityLoadingCapacitanceD.F.QI.R.DielectricStrengthY5P: Within ±10%Y5U: Within ±20%Y5V: Within ±30%SL&CH:Within±2.5%or±0.25pF,Whichever is large.Y5P,Y5U:5.0% max.Y5V:7.5% max.SL&CH:Less than 30pF=>Q≧ 100+10×C/3More than 30pF=>Q≧ 200Y5P&Y5U&Y5V:3000MΩ min.SL&CH: 1000MΩ min.Per Item 7.3.3Appearance No marked defect.CapacitanceY5P&Y5U&Y5V:Within ±20%SL&CH:Within±3%or±0.3pF,Whichever is large.Set the capacitor for 500±12hours at 40±2 ℃ in 90 to 95%relative humidity.1Then capacitor shall be stored for 1 to 2 hours at※ roomcondition.Apply the rated voltage for 500±12 hours at 40±2 ℃ in90 to 95% relative humidity and set it for 1 to 2 hours1at※ room condition.Impulse VoltageEach individual capacitor shall be subjected to 8kVimpulses for three times. After the capacitors areapplied to life test.Fig. 2I.R.3000MΩ min.SL&CH: 1000MΩ min.7.3.14Life7.3.15 Flame TestDielectricStrengthPer Item 7.3 3The capacitor flamediscontinues as follows.Cycle Time1~4 30sec max.5 60sec max.The specimen capacitors are placed in a circulating airoven for a period of 1000 hours. The air in the oven ismaintained at a temperature of125±3 ℃ . Throughout the test, the capacitors aresubjected to an AC425Vrms.(for 0AH type) orAC680Vrms.(for 1AH type) alternating voltage ofmains frequency, except that once each hour thevoltage is increased to AC1000V(rms.) for 0.1 sec.The capacitor shall be subjected to applied for 15 secand then removed for 15 sec until 5 cycles.Fig. 5(unit: mm)