Instruction manual Double Insulated Laminate Trimmers
Instruction manual Double Insulated Laminate Trimmers
Instruction manual Double Insulated Laminate Trimmers
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SUB-BASEINVERTED3 /16"➤➤Fig. 123. DISCONNECT TOOL FROM POWER SOURCE.4. Firmly grasp motor housing beingsure switch is in the “OFF” position.5. Verify bit is clear of foreign objectsand cord will not “hang up” on anyobstructions.6. Be sure workpiece is firmly held inplace. Use clamps where necessary tosecure workpiece.7. Plug in power supply cord. Be alertto resist starting torque of motor. Turnmotor “ON”.8. Allow motor to reach “full speed”.Fig. 13Place base of trimmer on surface to be trimmed and feed into work until bitpilot contacts base material. When guiding on a previously laminatedsurface, always wax or lubricate the area that trimmer will guide against.NOTE: While operating trimmer with tilt base at any tilt setting otherthan “0” degrees, the long side of the base must be keptperpendicular to the piloting surface to prevent possible workspoilage.9. Feed from left to right with a smooth steady motion (See Fig. 13).10. At completion of trimming operation, turn switch “OFF”. Allow motor tocome to a complete stop before laying trimmer down.17