Instruction manual Double Insulated Laminate Trimmers

Fig. 19 Fig. 205. Position the underscribe trimmer onto the face frame so that the top(see Fig. 19), is against the edge of the stile.NOTE: The trimmer should be to the right of the rail, so that thecutting action will move from right to left (see Fig. 19).6. Verify that bit is clear of foreign objects and that cord will not hang onany obstructions.7. Grasp motor firmly to resist starting torque and move switch button toON position.8. Allow motor to reach full-speed. Feed trimmer right to left with a smoothsteady motion.NOTE: The tapered edge of the underscribe base will slideunderneath the rail covering, lifting the laminate into the cutter.9. After completing the cut, move the switch button to the OFF positionand allow the motor to come to a complete stop before laying the trimmerdown.10. Press the rail end into position and roll down.11. Repeat the above process as necessary to complete the face frame.TROUBLESHOOTING GUIDEFor assistance with your tool, visit our website at www.porter-cable.com for alist of service centers or call the Porter-Cable help line at 1-800-487-8665.21