english

More documents

Recommendations

Info

Questions to identify which version to supply- Type of output (Danfoss, PWM, ON/OFF, CAN-BUS only…)Caution: there are Danfoss PWM (PVHC) models with Deutsch or AMP JPT connectors.- Operating voltage: 12V or 24V (for Danfoss models, the voltage is not important)- Type of output connector (or with terminal connectors – without cable)- Type of PCU (mini, maxi, linear lever, joystick)- number and position of the levers/joysticks- Switch-plate configuration (standard or special?)If there are additional switches, it is important to know:- the type (stable/detent or instable/spring-return)- the direction (standard horizontal or vertical?)- Transmission frequency (Europe CE 433 MHz / Nafta 900 MHz)- Any antenna extension3024/06/2011
Diagnostic modeThis is a special operating mode in which it is possible to access certaininformation regarding the system status.How to enter diagnostic modeIt is possible to enter during normal operation, via radio, by movingthe MICRO switch 15 times to the left (it is then necessary to push it to theright ones, to return to HARE mode - given that the last MICRO speed hasbeen reached). Nothing is shown on the PCU.OperationIn Diagnostic mode, the radio operates as normal.It is important to be able to see the display in the CU (through the window).If we are guiding the crane operator and we ask him what he can see onthe display, we can obtain a lot of information about the problem he is reporting.It is necessary to explain ourselves well and interpret what the operator isreading.3124/06/2011
Page 1 and 2: Scanreco RC400 - G2B System124/06/2
Page 3 and 4: G2B: 1-way 1and 2-way2Communication
Page 5 and 6: Commands on the PCUType of ON/OFF o
Page 7 and 8: Number of ON/OFF channels available
Page 9 and 10: Inputs under the switch-plates- min
Page 12 and 13: EX1EX2what G2were like1224/06/2011
Page 14 and 15: Types of panels for DUPLEX versions
Page 16 and 17: More screen to alternateExample of
Page 18 and 19: Speeds (and SETs) ) availablePARAME
Page 20 and 21: G2B Programming steps (2 of 2)Step
Page 22 and 23: CAN-BUS on all receiversAll the cen
Page 24 and 25: Example of application with CANBUSI
Page 26 and 27: Other differences between G1/G2 and
Page 28 and 29: Multi Transmitter ModePCU1Multiple
Page 32 and 33: Diagnostic modeThere are 8 diagnost
Page 34 and 35: Types of CU available3424/06/2011
Page 36: FABER-COM G2B standard - manoeuvre

english

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?