RTXM168-418

More documents

Recommendations

Info

RTXM168-418the module with a 4.7 – 10K resistor.Low (0 – 0.8V): Transmitter onBetween (0.8V and 2V): UndefinedHigh (2.0 – VccT): Transmitter DisabledOpen :Transmitter DisabledNote3: Mod-Def 0, 1, 2. These are the module definition pins. They should be pulled up with a 4.7 - 10Kresistor on the host board to supply less than VccT+0.3V or VccR+0.3V.Mod-Def 0 is grounded by the module to indicate that the module is present.Mod-Def 1 is clock line of two wire serial interface for optional serial ID.Mod-Def 2 is data line of two wire serial interface for optional serial ID.Note4: BPD (Burst Power Detect) is pulled up internally with a 10K resistor to VccR. When LOW, this outputindicates the received optical power is below the worst case receiver sensitivity (as defined by the standardin use). HIGH indicates normal operation. In the low state, the output will be pulled to
RTXM168-418Typical application circuitPackage outline(Units in mm)Wuhan Telecommunication Devices Co., Ltd.http://www.wtd.com.cn13
Page 1 and 2: RTXM168-418EPON OLT Optical Transce
Page 4 and 5: RTXM168-418Optical receive Characte
Page 6 and 7: RTXM168-418Memory Map2 wire address
Page 8 and 9: RTXM168-41808-09 2 Vcc High Alarm S
Page 10 and 11: RTXM168-418111 3 Rx Power A/D Valid
Page 14: RTXM168-418Regulatory ComplianceFea

RTXM168-418

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?