1:10 Scale Radio Controlled Electric Powered 4WD Buggy - Absima

Transmitter PreparationA new Ni-MH battery must be charged before it is used.Refer to the charger instruction manual for charging.Set up the radio control system as indicated belowBattery3MotorElectronic SpeedController2115879610ONOFF85TransmitterServo4Switch1610ONOFFReceiverStartFinishTools required1 Install batteries.(Transmitter)2 Extend the antenna.(Transmitter)3 Connect the battery4 Extend the antenna.(Reveiver)5 Center the trims.6 Switch on.(Transmitter)7 Switch on.(Reveiver)8 Make sure the servos are in command.9 Switch off.(Reveiver)10 Switch off.(Transmitter)11 Retract the antenna(Transmitter)1 2 3 4 5 6 7 8 9 10 11 Needie Nose Pllers Awi GreaseScrew CementInstant GlueBall differential Grease(Clear)SP KINFE EDGE REAMERWire CuttersROUND CUTTER&SANDERMolybdenum Grease(Black)Hex WrenchHex WrenchNo need to pre-drill precise holes(1mm to 15mm)can be drilledSharp Hobby knifeFor trimming bodies!