PowerFlex 400 Adjustable Frequency AC Drive ! ! !

English-8PowerFlex 400 Adjustable Frequency AC Drive Quick StartPower Terminal Block SpecificationsFrame Maximum Wire Size (1) Minimum Wire Size (1)(1) Maximum/minimum sizes that the terminal block will accept - these are notrecommendations. If national or local codes require sizes outside this range, lugs maybe used.Important: Frame C, D, and F drives utilize a finger guard over thepower wiring terminals. Replace the finger guard whenwiring is complete.Refer to the PowerFlex 400 User Manual for maximum power cablelength recommendations.Input Power ConditionsRecommendedTorqueC 8.4 mm 2 (8 AWG) 1.3 mm 2 (16 AWG) 2.9 N-m (26 lb.-in.)D 33.6 mm 2 (2 AWG) 8.4 mm 2 (8 AWG) 5.1 N-m (45 lb.-in.)E 480V37-45 kW(50-60 HP)33.6 mm 2 (2 AWG) 3.5 mm 2 (12 AWG) 5.6 N-m (49.5 lb.-in.)E240V30-37 kW(40-50 HP)480V55-75 kW(75-100 HP)107.2 mm 2 (4/0 AWG) 53.5 mm 2 (1/0 AWG) 19.5 N-m (173 lb.-in.)F 152.5 mm 2 (300 MCM) 85.0 mm 2 (3/0 AWG) 19.5 N-m (173 lb.-in.)Input Power ConditionLow Line Impedance (less than 1% linereactance)Corrective Action• Install Line Reactor (1)• or Isolation TransformerLine has power factor correction capacitors • Install Line Reactor (1)Line has frequent power interruptionsLine has intermittent noise spikes in excess of6000V (lightning)• or Isolation TransformerPhase to ground voltage exceeds 125% ofnormal line to line voltageUngrounded distribution system• Remove MOV jumper to ground(Frame C, E & F drives only)• or Install Isolation Transformer withgrounded secondary if necessary(1)Refer to the PowerFlex 400 User Manual for accessory ordering information.