12.07.2015 Views

Dodge Ram 2500 & 3500 - 2010-Newer Installation ... - RealTruck.com

Dodge Ram 2500 & 3500 - 2010-Newer Installation ... - RealTruck.com

Dodge Ram 2500 & 3500 - 2010-Newer Installation ... - RealTruck.com

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

On Passenger Side, run Wire Harness leg down andalong underside of the vehicle floor and frame to frontDrive Linkage. Connect harness to motor and secureharness with tie wraps. Route remainder of wire harnesstowards rear linkage assembly for LED lightsOn each side of the vehicle measure from the front edgeof door line on the pinch weld to the specifi ed lenghtsbelow. Measure at 22” for the front LED Light and 64-3/4”for the rear LED Light.35 36464-3/4”22”Drill a 9/32” hole through the pinch weld at markedlocations. Debur all holes.Insert grommet into drilled holes. Insert lamp wiresthrough the grommets. (Silicon lube will help wires slipthrough grommets.)191837 38Affix lamp to rocker panel surface. Make sure lampis affi xed to a flat, clean surface.Using supplied butt connectors, connect the lampwires. Red to Red, Black to Black2120222039 40www.amp-research.<strong>com</strong> 12/13IM75143 rev 04.12.12

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!