DynojetPS08:Layout 1.qxd - Dynojet Research

Ignition ModuleThe Dynojet Ignition Module is an “add on” accessory for select PowerCommander III USB. It allows you to control and adjust the ignition timingof your motorcycle’s engine.Rev X-tendOn select models of bikes our Rev X-tend feature isavailable when using the Ignition Module. Rev X-tend makesit possible to increase the RPM limit from the factory setting.This feature is intended to be used on engines that havebeen modified to allow the increased RPM limit.Go to www.powercommander.com for a list of Rev X-tendbike applicationsThe Ignition Module is connected to the PCIIIUSB with it’s built in expansion port link and communicates via a CAN interface. As in the case of thePower Commander, the Ignition Module uses OEM style connectors to plug in-line of the stock ignition harness so no cutting or splicing is required.The Ignition Module uses “direct coil driver technology” and allows a high degree of timing adjustment. In the Power commander Control CenterSoftware the user is able to advance or retard the ignition curve up to 10 degrees based on throttle position and RPM. It is also possible to alterthe timing for each cylinder individually if necessary.The Ignition Module comes standard with no adjustments made in the map for the timing table. Due to different states of tune, fuel quality, and enginemodifications we found it is best to leave the ignition timing stock for safety reasons. To have your ignition curve fine tuned Dynojet recommendsbringing your bike to one of our Authorized Power Commander Tuning Centers. These centers have the necessary dynamometer equipment toextract the most performance out of the Ignition Module.On motorcycles that have eight injectors and were not previously able to benefit from the use of the Dynojet Quick Shifter, the Ignition Module nowallows this functionality. The Dynojet Quick Shifter is connected to the expansion port between the Ignition Module and the PCIIIUSB.For available models please refer to the Power Commander application chart pages 5-914 Power Commander Accessories 2008Not for use with EX model Power Commanders