Masterpact NT06-16 IEC - error

Discovering Masterpact’saccessoriesIndication contactsE60050AElectrical reset after fault trip (Res)b optional equipment,one Res per deviceb not compatible with theSDE/2 optionb connectors notincluded, see below:v 110/130 V ACv 220/240 V ACb connectors:v for fixed devicev for drawout device.b the contact remotelyresets the devicefollowing tripping due toan electrical fault."Springs charged" limit switch contact (CH)b equipment includedwith MCH gear motor,one CH contact perdevice.b the contact indicatesthe "charged" status ofthe operating mechanism(springs charged).b changeover contactb breaking capacity 50/60 Hz for AC power(AC12 / DC12 as per947-5-1):V AC 240 10A(rms)380 6 A (rms)480 6 A (rms)690 3 A (rms)V DC 24/48 3 A125 0.5 A250 0.25 AE51332A"Ready to close" contact (PF)b optional equipment,one PF contact perdeviceb connectors notincluded, see below:v standardv low levelb connectors:v for fixed devicev for drawout device.b the contact indicatesthat the device may beclosed because all thefollowing are valid:v circuit breaker is openv spring mechanism ischargedv a maintained closingorder is not presentv a maintained openingorder is not present.b changeover contactb breaking capacity atcos ϕ = 0.3 (AC12 /DC12 as per 947-5-1)v standard, minimumcurrent 10 mA / 24 VV AC 240/380 5 A (rms)480 5 A (rms)690 3 A (rms)V DC 24/48 3 A125 0.3 A250 0.15 Av low level, minimumcurrent 1 mA / 4 VV AC 24/48 3 A (rms)240 3 A (rms)380 3 A (rms)V DC 24/48 3 A125 0.3 A250 0.15 A32Masterpact NT06-16 IECSchneider Electric