Installatiehandleiding en gebruiksaanwijzing Dru Apollo ... - UwKachel

INSTRUCTIONS FOR INSTALLATIONForewordDear Customer,We would like to thank you for buying this DRU product.Our products have been designed and produced to meetthe highest possible quality, performance and safetyrequirements, allowing you to enjoy years of problem-freeuse.The heater has an enclosed combustion chamber. Itsnatural draught draws in the combustion air from outsidethrough a combined inlet-outlet system. The same naturaldraught expels the combustion gasses.The safe operation of the appliance is guaranteed by theuse of a second thermocouple fitted to the main burner.In this booklet you will find instructions for the installationand use of your new appliance. Please read theseinstructions and the manual carefully to familiarize yourselfwith the appliance. If you require any further support,please do not hesitate to contact your supplier.UnpackingOnce the heater has been unpacked, all packaging shouldbe disposed of in the regular manner.ConnectionThis appliance should be connected by a registeredgasinstaller.Important• The chimney breast should be adequately vented.• The appliance must not be packed or covered in any waywhatsoever.• Always clean the glass pane before using the gas fire, toprevent any finger marks or other dirt getting burnt intothe glass.• This appliance may only be installed using the Ø150/Ø100flue material supplied by DRU.• NB: To ensure the ignition works properly, the ignitionwire must come into as little contact as possible withthe metal parts of the heater and should thereforenot be wound round the gas or pilot-light pipes or thethermocouple.• Make sure thermocouple 2 and the space around it arekept free.• Place the electrical wiring in such a way that they are freefrom the appliance.INSTRUCTIONS FOR INSTALLATIONType of gasThis appliance can only be used and is only suitable forthe country and the type of gas mentioned on the typeidentification tag. Please check that the local gas andpressure correspond with the specifications on the typeidentification tag. The type identification tag is a metalplate. Which is on the chain.All regulations regarding gas installation, including any localregulations, must be observed at all times. The appliance isto be installed by a registered gasinstaller.Important• Keep curtains and any other flammable materials at least50cm away form the appliance.• Caution! Touching the heater when hot can cause burnsand blisters!• The appliance should be installed and maintained by aregistered gasinstaller.• Do not install any so-called dust filter on or under the casing.• Do not hang wet clothes and towels etc. on the heater todry.Positioning the applianceThe appliance has been designed to be built snugly intoa newly built chimney breast of incombustible and heatresistantmaterial.For this appliance you will need to use a service flap.The service flap should be fitted within 1 metre left orright of the heater, to allow for the length of the wires.For the dimensions and installation instructions, see thesection on the service flap.If you build the chimney breast of any material other thanstone (e.g. Promatect), we advise you to use a fibreglasswallpaper and not plaster.If you do use plaster make sure the flanges are notplastered over as they could crack from the heat of the fire.Allow sufficient space for the depth of the appliance(500 mm).The appliance must not be mounted too closely againstthe back wall.The built-in height will depend on how high the adjustablefeet are set.Now move the appliance into the required position.Allow enough room all round the appliance in the fireplaceso that the heat can escape.To allow adequate heat removalthe chimney breast shouldbe well vented.The total free vent area should be at least 200 cm 2 .We advise you to fit vents on both sides.The DRU range includes suitable design vents.Take the bag of accessories out of the combustionchamber by removing the glass pane (see chapterRemoving the glass window).28