Installatiehandleiding en gebruiksaanwijzing Dru Apollo ... - UwKachel

OPERATING INSTRUCTIONSCaution- Do not place the antenna too close to the ignition cableand/or metal parts: make sure the antenna is pointingupwards (for the correct position, see fig. 23).- Make sure the ignition cable is not running over/alongside metal parts: this will weaken the spark.- Do not lay the ignition cable over the receiver: thiscould damage the receiver.aerialthermocouplewiringbutton Bhigh-voltagetransformerbutton Aignition wireCautionAlthough highly improbable, we cannot rule out that yourappliance’s ignition process can be started unintentionallythrough other remote controls. This could be the remotecontrol of your neighbours’ gas heater, but also car keysand garage door openers.The result will be that your appliance will burn when youdo not want it to.Unintended ignition of your appliance could be solved/prevented by:- Setting a new communication code between remotecontrol and receiver.- When left unattended for a longer period, set button Aon the gas control to the position MAN.- Close the gas tap near your appliance. This is the safestprecaution, if the appliance will not be used for a longerperiod.- Observe stated precautions / safety instructions - even ifthe appliance is not in use.Setting the communication codePrior to putting the application into operation, acommunication code must be set between the remotecontrol and the receiver. The code is chosen randomlyfrom the 65000 available codes. As a result, the chancethat other remote controls near you are using the samecode and affect the operation of your appliance is verysmall.fig. 23Remote controlThe appliance’s standard functions such as ignition,controlling the flame height, standby (pilot burner)position and switching off are performed in the MANposition, the manual control of the remote control (seefig. 24).In addition, the remote control can also be used to set anumber of additional functions:- Temperature displayin degrees Celsius orFahrenheit.- Time.- Thermostat function.- Timer for thermostatfunction.fig. 25Follow the procedure described below:• Hold down the reset button on the receiver, until youhear two consecutive sound signals (see fig. 25).• After the second, longer signal, let go of the reset button.• Press button (small flame) or button (large flame) onthe remote controlwithin 20 seconds, until you hear an extra long soundsignal: this is the confirmation of a correct communication.CautionWhen installing a new remote control or receiver, youmust set a new communication code.fig. 24MAN positionBy briefly pressing the SET button, you will go through thefollowing functions:MAN → ✹ TEMP → TEMP → (P*)TIMER → MANwhere, depending on the timer setting:46