Frequency inverter M-Max - Moeller

Parameters04/10 MN04020001Z-ENPNU ID Access rightRUNValue Description Factory setting(P1.3)P13.1 1453 - LOG function, Selection input A 00 DeactivatedValue range for signal A.1 READY, the frequency inverter is ready for operation.2 RUN, the inverter of the frequency inverter is enabled (FWD, REV).3 FAULT, error messageError detected (= STOP).4 Error message inverted (no error message).5 ALARM, warning message(a section “Protective functions (P8)”)6 REV (Reverse run), anticlockwise rotating field active7 Output frequency = frequency setpoint8 Motor controller active9 Zero frequencyOutput frequency = 0 (Hz)10 Frequency monitoring 1For the frequency ranges set at P5.4 and P5.5.11 Frequency monitoring 2For the frequency ranges set at P5.6 and P5.7.12 PID monitoringFor the deviation set at P9.1713 Overtemperature message14 Overcurrent control active.15 Overvoltage control active.16 PLC Sequence control active.17 PLC Sequence control, single step completed.18 PLC Sequence control, program cycle completed.19 PLC Sequence control, pause.20 Counter, value 1 reached.The counter value is f the trigger value set at P3.21 and can bereset by activating P3.24.21 Counter, value 2 reached.The counter value is f the trigger value set at P3.22 and can bereset by activating P3.24.22 RUN message active23 Setpoint error (live-zero).Message, AL 50 if the value of AI1 and/or AI2 goes below the4 mA or 2 V setpoint value (live zero) (P2.1 = 1, P2.5 = 1).24 LOG function fulfilled.Message if the logical operation of P13.3 is fulfilled (LOG = 1).25 PID controller, actual value monitoring.Message if the actual value is within the hysteresis set at P9.15and P9.16.122