The Selection and Use of Electrical Insulating Gloves of Electricians ...

More documents

Recommendations

Info

Reference 87Appendix A – Guidance Note on Selection, Use and Maintenance of94Insulating GlovesAppendix B – Questionnaire (English) of the Survey 112Appendix C – Questionnaire (Chinese) of the Survey 117x
Content of the StudyIn Chapter One, electrical accident statistics in HKSAR and the apparent safety problemsassociated with the use of insulating gloves, alone with the background of the study arepresented. The importance of the study to the industry is highlighted and the aim isestablished. Delimitations of the research are explained.Chapter Two is a review of the literature surveyed for the study. General perception ofsafety and potential electrical hazards are briefly addressed. Protective Strategies in termsof safe system of work and risk assessment are explained. Hierarchy of control on electricalhazards, legal requirement on live work and codes of practices on isolation are studied.National Standard and specification of electrical protective gloves are reviewed. What isknown and what is apparently not known are summarized at the end of this Chapter.Based on established study aim and the summary of reviewed literature, Chapter Three setsout the objectives of the study. The methodology of the survey, including pilot study, scopeof work, sampling strategy and questionnaire design are explained in details.Results of the study are discussed in Chapter Four. Graphical presentations of the findingare included to assist the interpretation, elucidation and elaboration of the findings.In Chapter Five, the survey results are summarized, and the conclusions reached arepresented. Recommendations based on the study and findings of the survey are presented atthe end of report.xi
Page 1 and 2: University of Western SydneyIn Conj
Page 3 and 4: AcknowledgementsWith specific refer
Page 5 and 6: • 90% of the electricians of the
Page 7 and 8: 2.1.3 Electrical Hazards 102.1.3.1
Page 9: 4.2.11 Allergy 695 Summary, Conclus
Page 15: List of IllustrationsIllustration T
Page 18: 1. IntroductionThis project focuses
Page 24 and 25: 2 The Study of Related Literature2.
Page 26 and 27: life, against which they have no de
Page 28 and 29: CurrentReaction1 milliamp Just a fa
Page 30 and 31: Codes ofPracticesGovernmentPublicEd
Page 32 and 33: • determine what can be done to r
Page 34 and 35: 2.2.4 Personal Protection DevicesTh
Page 36 and 37: Table 2 Classification of Work Cate
Page 38 and 39: Table 3 Grouping of Personal Protec
Page 40 and 41: Table 4 Selection Specification (So
Page 42 and 43: Table 5ProcedureConduct a riskasses
Page 44 and 45: 2.3.1 Hierarchy of Control on Elect
Page 46 and 47: from electricity in work activities
Page 48 and 49: • Maximum allowable current to pa
Page 50 and 51: • Circumference of wrist• Circu
Page 52 and 53: andProof Test Voltage is either the
Page 54 and 55: 2.4.4 BS 697 : 1986, Specification
Page 56 and 57: 2.4.6 JIS T 8112, Rubber gloves for
Page 58 and 59: 2.5 Summary: What is Known and What
Page 60 and 61:
3 Survey on the Selection and Use o
Page 62 and 63:
The electricians in the pilot study
Page 64 and 65:
3.2.3 Sampling StrategyThere is no
Page 66 and 67:
A flowchart was prepared to help th
Page 68 and 69:
4. Results of the Study4.1 Profile
Page 70 and 71:
4.2 Profile of the Electricians und
Page 72 and 73:
4.2.3 Years of Electrical Work Expe
Page 74 and 75:
4.2.4 Risk Assessment and Safety Ac
Page 76 and 77:
Table 22 tabulates the response of
Page 78 and 79:
Table 24 indicates the ranking of r
Page 80 and 81:
4.2.7 Where Were Insulating Gloves
Page 82 and 83:
Majority of the relies focused on p
Page 84 and 85:
Figure 17 shows that 55% of the REW
Page 86 and 87:
4.2.11 AllergyIn response to the in
Page 88 and 89:
applications and subsequent date re
Page 90 and 91:
5.3 RecommendationsBased on the fin
Page 92 and 93:
5.3.1.2 Special contact requirement
Page 94 and 95:
Illustration 1. To determineglove s
Page 96 and 97:
5.3.1.6 Puncture, snag, tear and cu
Page 98 and 99:
5.3.2.1 Air TestAir test should be
Page 100 and 101:
5.3.2.3 StretchingStretch the thumb
Page 102 and 103:
5.3.3 Maintenance Guide5.3.3.1 Stor
Page 104 and 105:
ReferenceAdam, J. 1995, Risk, UCL P
Page 106 and 107:
IEE - Health and Safety Briefing 34
Page 108 and 109:
Occupational Safety and Health Conv
Page 110 and 111:
Youngman, M. B. 1982, REDIGUIDE 12
Page 112 and 113:
Guidance NotesonThe Selection, Use
Page 114 and 115:
4. Electrical HazardsElectrical saf
Page 116 and 117:
5. Protective StrategiesUnder Secti
Page 118 and 119:
5.4 Hierarchy of Control on Electri
Page 120 and 121:
BS EN60903: 1993;D120-95 of ASTM199
Page 122 and 123:
6.5 Size and fitProper size and fit
Page 124 and 125:
6.6 Puncture, snag, tear and cut re
Page 126 and 127:
7.2 Hand Rolling and Pinch RollingS
Page 128 and 129:
8. Care and Maintenance of Insulati
Page 130 and 131:
Electrical Protective Gloves Survey
Page 132 and 133:
HAVE YOU CONSIDERED THE FOLLOWING F
Page 134 and 135:
Appendix CQuestionnaire (Chinese) o
Page 136 and 137:
9. / (Lockout/Tagout Procedure)? 1
Page 138:
30. ?, , ___________________31. ?
show all

The Selection and Use of Electrical Insulating Gloves of Electricians ...

Create successful ePaper yourself

Delete template?

Save as template?