- Page 1 and 2: University of Western SydneyIn Conj
- Page 3 and 4: AcknowledgementsWith specific refer
- Page 5 and 6: • 90% of the electricians of the
- Page 7 and 8: 2.1.3 Electrical Hazards 102.1.3.1
- Page 9 and 10: 4.2.11 Allergy 695 Summary, Conclus
- Page 11 and 12: Content of the StudyIn Chapter One,
- Page 15: List of IllustrationsIllustration T
- Page 18: 1. IntroductionThis project focuses
- Page 25 and 26: 2.1.2 Understanding RisksIn general
- Page 27 and 28: The perceptions of safety vary dram
- Page 29 and 30: 2.1.3.3 FallsEven low voltages at 8
- Page 31 and 32: 2.2.1 Safe System of WorkIn the Hea
- Page 33 and 34: such exposure to the workers. Propo
- Page 35 and 36: Table 2 Classification of Work Cate
- Page 37 and 38: Table 2 Classification of Work Cate
- Page 39 and 40: Table 3 Grouping of Personal Protec
- Page 41 and 42: The apparently oversimplified guide
- Page 43 and 44: AS/NZS 2161.1:2000, Occupational pr
- Page 45 and 46: • Substitution−−Use low volta
- Page 47 and 48: −−Over estimate one’s compete
- Page 49 and 50: 2.4 National Standard and Specifica
- Page 51 and 52: 2.4.2 Designation : D120-95 of ASTM
- Page 53 and 54: 2.4.3 Designation : F496-95a Standa
- Page 55 and 56: stretched by hand to ascertain that
- Page 57 and 58: (Type)(Rate Voltage) rms kV1 3 kV2
- Page 59 and 60: elements of insulating gloves selec
- Page 61 and 62: 3.2 MethodologyTo meet the study ob
- Page 63 and 64: Grade Permitted Class of Work No. o
- Page 65 and 66: 3.2.4 Questionnaire DesignThe quest
- Page 67 and 68: A draft questionnaire was prepared
- Page 69 and 70:
Amongst the 216 processed samples,
- Page 71 and 72:
4.2.2 Education Level81% of the sur
- Page 73 and 74:
The demographic and education chara
- Page 75 and 76:
It was noted that 44% of the survey
- Page 77 and 78:
4.2.6 Experience of Insulating Glov
- Page 79 and 80:
Figure 13Responses to the question
- Page 81 and 82:
4.2.8 Selection CriteriaWhen asked
- Page 83 and 84:
4.2.9 Use of Insulating GlovesThose
- Page 85 and 86:
4.2.10 Inspection and Tests of Glov
- Page 87 and 88:
5. Summary, Conclusions and Recomme
- Page 89 and 90:
5.2 ConclusionsGiven the scope of t
- Page 91 and 92:
5.3.1.1 Maximum Usage VoltageVoltag
- Page 93 and 94:
5.3.1.3 Dexterity requirementsLost
- Page 95 and 96:
DetailsGlove Size8 9 10 11Circumfer
- Page 97 and 98:
5.3.2 Application GuideInsulating g
- Page 99 and 100:
5.3.2.2 Hand Rolling and Pinch Roll
- Page 101 and 102:
• Soiled gloves should be cleaned
- Page 103 and 104:
5.4Recommendations for Further Stud
- Page 105 and 106:
Chmiel, Nik 2000, Introduction to W
- Page 107 and 108:
McGuinnes, Pat and Smith, Lynn 1999
- Page 109 and 110:
The Office of Health and Safety Inf
- Page 111 and 112:
Appendix AGuidance NotesonThe Selec
- Page 113 and 114:
1. BackgroundThere are no official
- Page 115 and 116:
Figure 1 Effects of current passing
- Page 117 and 118:
The safe system of work can be cons
- Page 119 and 120:
• Substitution− Use low voltage
- Page 121 and 122:
6.2 Special contact requirementsIns
- Page 123 and 124:
Dimensions of gloves may be differe
- Page 125 and 126:
7.1 Air TestAir test should be cond
- Page 127 and 128:
Figure 8 To stretch thecrotches are
- Page 129 and 130:
Appendix BQuestionnaire (English) o
- Page 131 and 132:
10. How often do you encounter live
- Page 133 and 134:
30. Where do you store your electri
- Page 135 and 136:
: UWS . . , 2002 8 30 .! : 31. : 1
- Page 137 and 138:
, ? 15. 16. 17. 18. 19