Rear Suspension - - Freel2.com

More documents

Recommendations

Info

http://topix.landrover.jlrext.com/topix/service/procedure/146634/OD...3 of 6 23/02/2012 7:36 AM8.NOTE: Bearing damage is unavoidable during thisoperation.Position the wheel knuckle assembly in a pressand support on special tool.Special Tool(s): 205-802/5Press the drive flange out of the wheel knuckleassembly using special tool.Special Tool(s): 205-7259.NOTE: The inner bearing track will remain on the driveflange.10.Clamp both halves of a suitable bearing separatoraround the inner bearing track and position thedrive flange in a press.Using the special tool, press the drive flange fromthe inner bearing track.Special Tool(s): 205-725
http://topix.landrover.jlrext.com/topix/service/procedure/146634/OD...4 of 6 23/02/2012 7:36 AM11. Remove the circlip from the wheel knuckle assembly.12.Position the wheel knuckle assembly in a pressand support on special tools.Special Tool(s): 205-728Press the wheel bearing out of the wheel knuckleassembly using special tool.Special Tool(s): 205-726Installation1.CAUTION: One side of the bearing is magnetic. Themagnetic side is identifiable by the application of a mattblack finish. The magnetic side must face towards theinboard side of the vehicle. Before fitting the bearing,make sure the magnetic face is clean. The bearing mustbe handled with extreme care.Position the wheel knuckle assembly in a pressand support on special tool.Special Tool(s): 204-528/2Press the new wheel bearing into the wheelknuckle assembly using special tool.Special Tool(s): 205-7262.Install the circlip to the wheel knuckle assembly.
Page 5 and 6: http://topix.landrover.jlrext.com/t
Page 9: http://topix.landrover.jlrext.com/t
Page 32: http://topix.landrover.jlrext.com/t

Rear Suspension - - Freel2.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?