Rear Suspension - - Freel2.com

http://topix.landrover.jlrext.com/topix/service/procedure/146634/OD...4 of 6 23/02/2012 7:36 AM11. Remove the circlip from the wheel knuckle assembly.12.Position the wheel knuckle assembly in a pressand support on special tools.Special Tool(s): 205-728Press the wheel bearing out of the wheel knuckleassembly using special tool.Special Tool(s): 205-726Installation1.CAUTION: One side of the bearing is magnetic. Themagnetic side is identifiable by the application of a mattblack finish. The magnetic side must face towards theinboard side of the vehicle. Before fitting the bearing,make sure the magnetic face is clean. The bearing mustbe handled with extreme care.Position the wheel knuckle assembly in a pressand support on special tool.Special Tool(s): 204-528/2Press the new wheel bearing into the wheelknuckle assembly using special tool.Special Tool(s): 205-7262.Install the circlip to the wheel knuckle assembly.