Rear Suspension - - Freel2.com

More documents

Recommendations

Info

http://topix.landrover.jlrext.com/topix/service/procedure/146634/OD...2 of 2 23/02/2012 7:37 AMCAUTIONS:Make sure that these components are installed to the notedremoval position.Make sure that the mating faces are clean and free of foreignmaterial.Install the spring.3.Install the spring inclination spacer and top mount, install the nut butdo not fully tighten at this stage.4.Carefully release the spring tension.5.Tighten the nut.Torque: 80 Nm6.Install the cap.7.Install the shock absorber and spring assembly.Refer to: Shock Absorber and Spring Assembly (204-02 RearSuspension, Removal and Installation).
http://topix.landrover.jlrext.com/topix/service/procedure/146634/OD...1 of 4 23/02/2012 7:37 AMRear Suspension - Shock Absorber and Spring AssemblyRemoval and InstallationPublished: 11-May-2011Removal1.Remove the rear quarter trim panel.Refer to: Rear Quarter Trim Panel (501-05 Interior Trim andOrnamentation, Removal and Installation).2.WARNING: Make sure to support the vehicle with axle stands.Raise and support the vehicle.3.Remove the wheel and tire.Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal andInstallation).4.CAUTION: Make sure that no load is placed on thebrake hose.5.CAUTION: Discard the nut.
Page 5 and 6: http://topix.landrover.jlrext.com/t
Page 32: http://topix.landrover.jlrext.com/t
Page 37: http://topix.landrover.jlrext.com/t

Rear Suspension - - Freel2.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?