Rear Suspension - - Freel2.com

More documents

Recommendations

Info

http://topix.landrover.jlrext.com/topix/service/procedure/146634/OD...4 of 4 23/02/2012 7:37 AMSupport weight of vehicle on a jack at the rear hub.8.Tighten the trailing arm nut and bolt.Torque: 270 Nm9.Tighten the front and rear lower arm nuts and bolts.Torque: 175 Nm10.Install the wheel and tire.Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal andInstallation).11.Install the rear quarter trim panel.Refer to: Rear Quarter Trim Panel (501-05 Interior Trim andOrnamentation, Removal and Installation).
http://topix.landrover.jlrext.com/topix/service/procedure/146634/OD...1 of 2 23/02/2012 7:37 AMRear Suspension - Wheel Knuckle Rear BushingRemoval and InstallationPublished: 11-May-2011Special Tool(s)204-620-01Installer, Wheel Knuckle Bushing204-620-02Remover/Installer, Wheel Knuckle Bushing204-620-03Remover, Wheel Knuckle BushingLR-121Hydraulic Cylinder 10tRemoval1.WARNING: Make sure to support the vehicle with axle stands.Raise and support the vehicle.2.Remove the wheel and tire.Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal andInstallation).3.Remove the trailing arm.Refer to: Trailing Arm (204-02 Rear Suspension, Removal andInstallation).
Page 5 and 6: http://topix.landrover.jlrext.com/t
Page 32: http://topix.landrover.jlrext.com/t
Page 41: http://topix.landrover.jlrext.com/t

Rear Suspension - - Freel2.com

Create successful ePaper yourself

Delete template?

Save as template?