316 Stainless Steel, Bronze and Cast Iron Models - SHURflo Industrial

More documents

Recommendations

Info

CENTRIFUGAL PUMPSClose-Coupled Centrifugal Pumps316 Stainless Steel, Bronze and Cast Iron ModelsPrice List and Specifications for Standard Pump and Motor Models$ListPriceDRIVERPUMP CONSTRUCTION (Wet End)AC Full Service Port ShipModel Motor NEMA Motor Load Factor Overload Size Motor WtNumber HP Type Frame Voltage Amps Amps ** Phase Hertz Protection RPM Shaft FNPT Body Impeller Adapter Seals* (lbs.)Cast Iron ModelsCOMCB11 1/3 ODP 56J 115/208-230 7.20/4.00-3.60 8.68/4.78-4.33 1 60 Yes 3450 303 SS 1" X 3/4" CI CI CI Buna-N 27COMCB22 1/2 ODP 56J 115/208-230 11.10/6.50-5.55 12.4/6.80-6.20 1 60 Yes 3450 303 SS 1 1 ⁄4" x 1" CI CI CI Buna-N 30COMCB223 1/2 ODP 56J 208-230/460 1.85-1.85/0.92 2.53/1.27 3 60 No 3450 303 SS 1 1 ⁄4" x 1" CI CI CI Buna-N 30190/380 2.04/1.02 ** 3 50 No 2830COMCB33 3/4 ODP 56J 115/208-230 13.00/7.20-6.50 15.30/8.45-7.65 1 60 Yes 3450 303 SS 1 1 ⁄4" x 1" CI CI CI Buna-N 33COMCB333 3/4 ODP 56J 208-230/460 2.45-2.39/1.20 3.59/1.80 3 60 No 3450 303 SS 1 1 ⁄4" x 1" CI CI CI Buna-N 32190/380 2.88/1.44 ** 3 50 No 2830COMCB44 1 ODP 56J 115/208-230 12.40/6.85-6.20 15.70/8.70-7.85 1 60 Yes 3450 303 SS 1 1 ⁄2" x 1 1 ⁄4" CI CI CI Buna-N 40COMCB443 1 ODP 56J 208-230/460 3.17-3.11/1.55 4.07/2.03 3 60 No 3450 303 SS 1 1 ⁄2" x 1 1 ⁄4" CI CI CI Buna-N 40190/380 3.70/1.83 ** 3 50 No 2830COMCB55 1 1 ⁄2 ODP 56J 115/208-230 17.00/9.35-8.50 21.00/10.40-10.50 1 60 Yes 3450 303 SS 1 1 ⁄2" x 1 1 ⁄4" CI CI CI Buna-N 44COMCB553 1 1 ⁄2 ODP 56J 208-230/460 4.50-4.26/2.13 5.55/2.77 3 60 No 3450 303 SS 1 1 ⁄2" x 1 1 ⁄4" CI CI CI Buna-N 42190/380 5.18/2.59 ** 3 50 No 2830COMCB66 2 ODP 56J 115/208-230 23.00/12.60-11.50 24.5/13.5-12.25 1 60 Yes 3450 303 SS 1 1 ⁄2" x 1 1 ⁄4" CI CI CI Buna-N 56COMCB66T 2 TEFC 56J 115/208-230 19.40/10.70-9.70 22.16/11.08 1 60 Yes 3450 303 SS 1 1 ⁄2" x 1 1 ⁄4" CI CI CI Buna-N 65COMCB663 2 ODP 56J 208-230/460 5.80-5.20/2.60 6.20/3.10 3 60 No 3450 303 SS 1 1 ⁄2" x 1 1 ⁄4" CI CI CI Buna-N 56190/380 6.40/3.20 ** 3 50 No 2830COMCB663T 2 TEFC 56J 208-230/460 5.92-5.36/2.68 6.00/3.00 3 60 No 3450 303 SS 1 1 ⁄2" x 1 1 ⁄4" CI CI CI Buna-N 65190/380 6.30/3.15 *** 3 50 No 2830COMCB77 3 ODP 56J 208-230 15.30-13.50 ** 1 60 Yes 3450 303 SS 2" x 1 1 ⁄2" CI CI CI Buna-N 70COMCB77T 3 TEFC 56J 208-230 13.30-12.20 ** 1 60 Yes 3450 303 SS 2" x 1 1 ⁄2" CI CI CI Buna-N 75COMCB773 3 ODP 56J 208-230/460 8.42-7.65/3.83 9.00/4.50 3 60 No 3450 303 SS 2" x 1 1 ⁄2" CI CI CI Buna-N 70190/380 6.32/3.16 ** 3 50 No 2830COMCB773T 3 TEFC 56J 208-230/460 8.30-7.60/3.80 8.40/4.20 3 60 No 3450 303 SS 2" x 1 1 ⁄2" CI CI CI Buna-N 75190/380 6.20/3.10 ** 3 50 No 2830See footnotes and notes on the bottom of page 4.Source: Owner’s Manual L-4073 (12/09)8www.shurfloindustrial.comEffective 1/1/2011Form 45-SHU
SHURflo Pedestal-Mount Centrifugal Pumps316 Stainless Steel, Bronze and Cast Iron ModelsRefer to form L-4077 for General Operating and Safety Instructions and Applicable Warranty.DescriptionSHURflo pedestal cast iron, bronze or 316 stainless steel units pump continuously, producing high flow rates under low-headconditions. Designed for continuous low-pressure circulation and transfer of nonflammable liquids, utility, boiler feed,general transfer, filtration, cooling towers, condensate return, marine applications, fountains, boosters, water circulation,irrigation, spraying systems, jockey pump service, chemical processing, aggressive liquid applications and other generalpurposepumping compatible with pump component materials where no suction lift or no self-priming is required.• Capacities to 170 GPM, heads to 74 ft.• 1/3 to 3 HP AC requirements (motors not included).• Clog-resistant, semi-open metallic impellers.• Pumps feature maintenance-free ball bearings and an easily accessible front drain plug for draining liquid.• Maximum casing working pressure is 200 PSI.• 3/4" to 2" female NPT inlet and outlet ports.• Discharge port can be rotated at 90-degree intervals.• Standard pump models (at 3450 RPM) will handle specific gravities to 1.1 (at 100 SSU or less). For specific gravities to 1.4(at 100 SSU or less), increase motor HP by one size but not to exceed standard 3 HP motor at 3450 RPM or 65 in.-lbs. of torquemaximum. Higher specific gravity fluids are not recommended.• Standard pump models (at 3450 RPM) will handle viscosity to 100 SSU (at 1.1 specific gravity or less) and up to 200 SSU(specific gravity of 1.0 or less). For viscosity up to 400 SSU (specific gravity of 1.0 or less), increase motor HP by one size but notto exceed standard 3 HP motor at 3450 RPM or 65 in.-lbs. of torque. For fluids with a viscosity greater than 400 SSU, pumpspeed must be reduced below 3450 RPM.• Cast Iron and Bronze units handle temperatures to 200° F; Stainless Steel units handle temperatures to 250° F.• Seals: Pumps are equipped with a carbon ceramic mechanical seal having 316 stainless steel components. These sealsprotect the pump shaft, which is 316 series stainless steel, from chemical exposure. Buna-N seal and o-ring in cast iron andbronze models, with Viton seal and o-ring in 316 stainless steel models. Aftermarket options listed below.SHURFLO CLOSE-COUPLED PUMPS – Motor-driven models with NEMA 56J motor frame and base are available.REPAIR SEALS AND OPTIONS – Standard (Viton & Buna-N) and an upgraded (Silicon Carbide) seal are available. If abrasiveor small, particulated fluids are being pumped, an upgrade to the silicon carbide mechanical seal with Viton elastomers isrecommended. Standard and upgraded seals can be located in the repair parts list pages in this manual.CENTRIFUGAL PUMPSDo not use to pump flammable or explosive fluids such as gasoline, fuel oil,kerosene, etc. Do not use in flammable and/or explosive atmospheres. Whenpumping hazardous or dangerous materials, use only in room or area designated forthat purpose. For your protection, always wear proper clothing, eye protection, etc. incase of any malfunction. For proper handling techniques and cautions, contact yourchemical supplier, insurance company and local agencies (fire dept., etc.). Failure tocomply with this warning could result in personal injury and/or property damage.Pumps are not self-priming and cannot suction lift, flooded inletis required. If inlet is not flooded when the pump is running,seal failure will result and is not covered under the manufacturer’s warranty.Effective 1/1/2011Form 45-SHUsales@shurfloindustrial.comSource: Owner’s Manual L-4075 (12/09)9
Page 3: has a new name “SHURflo Industria
Page 6: CENTRIFUGAL PUMPSSHURflo Close-Coup
Page 9: SHURflo Close-Coupled Centrifugal P
Page 13 and 14: Pedestal-Mount Centrifugal Pumps316
Page 15 and 16: SHURflo High Head Close-Coupled Cen
Page 17 and 18: SHURflo High Head Close-Coupled Cen
Page 19 and 20: SHURflo High Head Pedestal-MountCen
Page 21 and 22: 316 Stainless Steel, Bronze and Cas
Page 23 and 24: SHURflo Corrosion-Resistant Close-C
Page 25 and 26: SHURflo Corrosion-Resistant Close-C
Page 27 and 28: SHURflo Corrosion-Resistant Pedesta
Page 29 and 30: SHURflo Self-Priming Close-CoupledC
Page 31 and 32: Self-Priming Close-Coupled Centrifu
Page 33 and 34: SHURflo Small Close-Coupled DC Cent
Page 35 and 36: SHURflo Close-Coupled Turbine Pumps
Page 37 and 38: SHURflo 316 Stainless Steel RotaryC
Page 39 and 40: 316 Stainless Steel Rotary Close-Co
Page 41 and 42: SHURflo 316 Stainless Steel RotaryP
Page 43 and 44: Viton Models GPSV2, GPSV4 and GPSV6
Page 45 and 46: SHURflo Heavy-Duty Cast Iron and Br
Page 53 and 54: SHURflo Carbonator-Mount RotaryClos
Page 55 and 56: SHURflo Bronze Plate-Mount RotaryCl
Page 57 and 58: Bronze Plate-Mount Rotary Close-Cou
Page 59 and 60: Light-Duty Pedestal Rotary External
Page 61 and 62:
SHURflo NSF Commercial-Duty Filter
Page 63 and 64:
aModels NR3, NR5, NR8, NR3-PH, NR5-
Page 65 and 66:
SHURflo Commercial-Duty Filter and
Page 67 and 68:
SHURflo Carbonator-Mount Hot OilNSF
Page 69 and 70:
Cast Iron Models GN60, GN63, GN70 a
Page 71 and 72:
SHURflo 316 Stainless Steel Close-C
Page 73 and 74:
SHURflo Bronze Close-CoupledSelf-Pr
Page 75 and 76:
Models MRB9000, MRB9001, MRB9900,MR
Page 77 and 78:
SHURflo Bronze Pedestal Self-Primin
Page 79 and 80:
SHURflo Heavy-Duty Cast Iron and Br
Page 81 and 82:
C-Face Frame AC Motors for Close-Co
Page 83 and 84:
SHURflo Self-Priming Close-Coupled
Page 85 and 86:
Centrifugal and Turbine Pump Series
Page 87 and 88:
How to Select Rotary Gear Pumps(NOT
Page 89 and 90:
Owner’s Manual Reference ListThe
Page 91 and 92:
CHMCV67CHMPB1XSelf-Priming Close-Co
Page 93 and 94:
ACCESSORIESDC Motors for Small182-1
Page 95 and 96:
Warranty for SHURflo ProductsSHURfl
show all

316 Stainless Steel, Bronze and Cast Iron Models - SHURflo Industrial

Create successful ePaper yourself

Delete template?

Save as template?