2011 Proto Rail Paintball Gun Service Manual - Wolfpack Paintball ...

HYPER3 IN-LINE REGULATORADJUSTMENTS AND MAINTENANCEVELOCITY ADJUSTMENTThe velocity of the RAIL is adjusted by adjusting the inputpressure into the RAIL. This is controlled with the Hyper3regulator. The Hyper3 on the RAIL is factory set to 150 psi whichwill give you a velocity of about 285 FPS (Feet per Second).A 3⁄16” allen key will be needed for this operation. Turning theadjustment screw in (clockwise) will decrease the pressure, and out(counterclockwise) will increase the pressure. To adjust thevelocity:1. Make sure you and everybody around you is wearing ASTM/CEapproved paintball goggles.2. Shoot the RAIL over a paintball chronograph.3. To lower the velocity turn the Hyper3 adjustment screw in. Toincrease the velocity turn the screw out. Only turn the screw aquarter turn at a time and shoot over the chronograph again.Notice that a few shots are needed before the change can beseen on the chronograph.MAINTENANCE20For the RAIL to function properly, it is essential that the inputpressure into the marker stays consistent at all times. The generalmaintenance needed for the Hyper3 regulator is to keep it cleanof dirt and debris at all times. A more extensive service should beperformed every 12 months by a trained Tech or if the outputpressure of the regulator becomes inconsistent. This can be seenas inconsistent velocity and verified with a regulator tester (soldseparately). Notice that the Hyper3 has a break in period ofabout 2000 shots before it achieves the best performance.W W W . P R O T O P A I N T B A L L . C O M