Superheat Controller| Doc V2.1 |HVAC Software ... - Microstaq
Superheat Controller| Doc V2.1 |HVAC Software ... - Microstaq
Superheat Controller| Doc V2.1 |HVAC Software ... - Microstaq
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
INTRODUCTION<br />
This software guide is intended to instruct the user about<br />
installing, configuring and operating DunAn <strong>Microstaq</strong>’s<br />
Universal SuperHeat Sensor software interface.<br />
The software version supported by this guide is:<br />
� Universal SuperHeat Sensor Interface v1.4<br />
DEFINITIONS<br />
� USHS – Universal SuperHeat Sensor<br />
CONVENTIONS<br />
The following are the conventions used in this application guide:<br />
� Note will be represented as:<br />
� All warnings and cautions will be represented as:<br />
FEATURES<br />
The USHS Interface includes the following features:<br />
� Pressure and temperature measurements<br />
� <strong>Superheat</strong> calculation<br />
� Data recording<br />
� Plotting superheat graph<br />
� Automatic detection of supply voltage<br />
� Alarms detection<br />
� Serial communication capability<br />
� Multiple unit communication capability<br />
Universal SuperHeat Sensor |<strong>Software</strong> Interface Guide Rev 2.2<br />
HARDWARE AND SOFTWARE REQUIREMENTS<br />
The following table provides the hardware and software requirements<br />
for installing and using the USHS Interface.<br />
Hardware Requirements System Requirements<br />
� DunAn <strong>Microstaq</strong> USHS<br />
� USHS Wiring Harness<br />
� Isolated USB to RS485 Converter<br />
� Laptop or Desktop PC<br />
� Small Flat Tip Screwdriver<br />
� Wire Stripper<br />
GETTING STARTED<br />
� Microsoft Windows<br />
Vista, Windows XP, or<br />
Windows 7 operating<br />
system<br />
This section provides instructions for installing, setting up, and using<br />
the USHS Interface.<br />
USHS INTERFACE INSTALLATION<br />
This section provides instructions to delete previous versions and<br />
install the latest version of the DunAn <strong>Microstaq</strong> USHS Interface.<br />
Complete uninstallation steps only if a previous version<br />
of the USHS Interface is installed. If not applicable,<br />
proceed to installation instructions.<br />
To delete the previous versions of the USHS Interface, complete the<br />
following steps:<br />
1. Navigate to the Control Panel<br />
2. Click Programs -> Uninstall a program<br />
Innovations that flow 1