S428A Manual - Danaher Specialty Products

DYNAPAR brand PRODUCT MANUAL: Series S428A 1/8 DIN Process IndicatorOutput ConnectionsOption Slot 2 - Relay ModuleIf option slot is fitted with a relay outputmodule, make connections as illustrated.22N/COption Slot 2 - Triac ModuleIf option slot is fitted with a Triac outputmodule, make connections as illustrated.2324∼ AC to Load2324COMN/OTriac Rating: 0.01 to 1 amp @ 240V AC50/60Hz. Use only to switch external load.Do not apply AC mains directly acrossterminalsContact Rating: 2 amps resistive,120/240 VAC.Option Slot 2 - SSR Driver ModuleIf option slot is fitted with an SSR driveroutput module, make connections as illustrated.The solid-state relay driver is a 0-10V DC signal, load impedance must be noless than 500 ohms. SSR driver outputs arenot isolated from the signal input or otherSSR driver outputs.Option Slot 2 - Linear Voltage or mADCmoduleIf option slot is fitted with a DC linear outputmodule, make connections as illustrated.222324- (minus)+ (plus)222324- (minus)+ (plus)Option Slot 2 - Dual Relay ModuleIf option slot is fitted with a dual relay outputmodule, make connections as illustrated.This module has two independent relays,which share a common connection terminal.22N/O Output 423COM24N/O Output 2Contact Rating: 2 amps resistive,120/240 VAC.2.10Manual Number: 702683-0001 Rev.: A August, 2006 Installation