Pr o Minent

More documents

Recommendations

Info

Operating Menu / DescriptionError message Condition EffectDuring calibration procedure:Buffer distance too small ∆Buffer
Operating Menu / DescriptionTo carry out this function, see priming menu.Priming:priming acidpress -key* pump oncontrol stop !orpriming chlorpress -key* pump oncontrol stop !To prime with pH corrective agent or oxidant, press the change key to access the Prime (acid/alkali) orPrime oxidant settings menu. Press the Up key, the control variable will jump to 100 % and the pump willrun for approx. 30 sec. The same applies if the Start/stop key is pressed or if metering stops due to anerror signal.Stop priming:press any keyEvery time you press the Up key the pump will prime for approx. 30 seconds.Recommence control:Access permanent display 1 and press the Start/stop key.LimitsWhen setting the check out time, metering of the corresponding pump is stopped and an alarm is triggeredthrough the alarm relay in the event of limit violations exceeding the set check out time.For devices with limit relays, a limit value or a zone may be set for each measuring value, where the relay willswitch.limitssetting?limitvalue 1 pHlimit 1 upper8.00 pHlimit 2 lower6.50 pHonly with limit relaylimit 1 upper8.00 pHlimit 2 lower6.50 pHlimit relay: LV1- active closed∆t on 0 s∆t off 0 shysteresis limit:0.20 pHcheckout time limit:offlimitvalue 2 ORPlimit 1 lower600 mVlimit 2 upper800 mVonly with limit relaylimit 1 lower600 mVlimit 2 upper800 mVlimit relay: LV1- active closed∆t on 0 s∆t off 0 shysteresis limit:10 mVcheckout time limit:offlimitend13
Page 2: 1 Device Identification / Identity
Page 9 and 10: Operating Menu / Overviewlimitendco
Page 11: 8 Operating Menu / DescriptionPerma
Page 16 and 17: Operating Menu / DescriptionPumpsTh
Page 18 and 19: Operating Menu / DescriptionOutputs
Page 20 and 21: Operating Menu / DescriptionPossibl
Page 22 and 23: Technical TermsTemperaturecorrectio
Page 24: Fault Fault text Symbol Effect Alar

Pr o Minent

Create successful ePaper yourself

Delete template?

Save as template?