Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>DCA</strong>-<strong>600SSV</strong> — OUTPUT TERMINAL PANEL CONNECTIONS3Ø-480V UVWO Terminal Output Voltages1. Jumper the voltage change-over board for 480V operationas shown in Figure 25. This configuration uses 6 jumperplates in 3 different positions. Remember there are 2jumper plates at every position. Every jumper plate mustbe used.1Ø-480V UVWO Terminal Output Voltages1. Make sure the voltage change-over board is jumperedfor 480V operation as shown in Figure 25.2. Connect the load wires to the UVWO terminals as shownin Figure 27.Figure 265 Voltage Change-Over Board480V Configuration2. Connect the load wires to the UVWO terminals as shownin Figure 26.Figure 27. UVWO Terminal Lugs1Ø-480V Connections1Ø-277V UVWO Terminal Output Voltages1. Make sure the voltage change-over board is jumperedfor 480V operation as shown in Figure 25.2. Connect the load wires to the UVWO terminals as shownin Figure 28.Figure 26. UVWO Terminal Lugs3Ø-480V ConnectionsNOTEALWAYS make sure that theconnections to the UVWOterminals are secure and tight.The possibility of arcing exists,that could cause a fire.DANGER - UVWO OUTPUT TERMINALSFigure 28. UVWO Terminal Lugs1Ø-277V ConnectionsNEVER attempt to connect a load to the UVWO outputterminals while the generator is operating. The possibilityexists of serious injury, electrical shock, electrocution evendeath.<strong>DCA</strong>-<strong>600SSV</strong> — OPERATION AND PARTS MANUAL — REV. #0 (07/13/09) — PAGE 33
Change language