DCA-600SSV Manual - Multiquip Inc.

DCA-600SSV — GEN. START-UP PROCEDURE (MANUAL)BEFORE STARTINGCAUTION - LETHAL EXHAUST HAZARD3. Place the G.F.C.I. and aux. circuit breakers (Figure 42) in the“OFF” position prior to starting the engine.The engine's exhaust contains harmful emissions.ALWAYS have adequate ventilation when operating.Direct exhaust away from nearby personnel.If applicable perform the following:■ Apply commercial power to the internal battery chargerreceptacle (to ensure good starting) via commercial power.An external power cord will be required. This capability is anoption.■ Apply commercial power to the jacket water heaterreceptacle (not necessary for warm climates) via commercialpower. An external power cord will be required. This capabilityis an option.Generator and Control PanelWARNING - STARTING THE GENERATORNEVER! manually start the engine with the main, GFCIor auxiliary circuit breakers in the ON (closed) position.1. Press the main circuit breaker “OFF” switch (Figure 40).Figure 42. GFCI and AuxiliaryCircuit Breakers (OFF)4. Connect the load to the UVWO terminals or auxiliaryreceptacles as shown in Figure 43. These loadconnection points can be found on the output terminalpanel. To gain access to the UVWO terminals or otherpower receptacles, unlock the access cover and lift thedoor.5. Tighten the UVWO terminal nuts securely to preventload wires from slipping out.Figure 40. Main Circuit Breaker OFF Switch2. Verify that the main circuit breaker “OFF” lamp (Figure 41)is lit (ON).Figure 43. Load Connections6. Close all engine enclosure doors (Figure 44).Figure 41. Main Circuit Breaker OFF LampCORRECTINCORRECTFigure 44. Engine Enclosure DoorsDCA-600SSV — OPERATION AND PARTS MANUAL — REV. #0 (07/13/09) — PAGE 39